Husqvarna LB 146I Lawn Mower

Operator's Manual - Page 18

For LB 146I.

PDF File Manual, 624 pages, Read Online | Download pdf file

LB 146I photo
Loading ...
Loading ...
Loading ...
LED on the battery Cause Solution
The error LED flashes. The battery is weak. Charge the battery. Refer to
To charge the battery
on page 13
.
The temperature in the work environ-
ment is too high or too low.
Use the battery in temperatures between -10°C
and 40°C.
Overvoltage. Make sure that the mains voltage is the same as
on the rating plate on the product.
Remove the battery from the battery charger. Wait
5 seconds and try again to charge the battery. If
the problem continues, speak to an approved
service agent.
The error LED is on. The cell difference too much (1V). Speak to an approved service agent.
Battery charger
LED on the battery
charger
Cause Solution
The error LED flash-
es.
The temperature in the work en-
vironment is too high or too low.
Use the battery charger in temperatures between 5°C
and 40°C.
The error LED is on. Speak to an approved service agent.
Control panel
For problems, other than those in this section, speak to
your service agent.
Keypad Error code (Num-
ber of flashes)
Possible faults Possible action
Error LED flashes 3 The motor is overloaded Increase the cutting height. See
To set
the cutting height on page 13
.
5 The motor speed drops too
much, and the motor stops
10 The motor control is too hot Stop the motor and wait until it has be-
come cool
2 The blade is blocked To prevent accidental start turn the safe-
ty key to 0, remove the battery and wait
a minimum 5 seconds. Make sure that
the blade can rotate freely. If the prob-
lem continues, speak to an authorised
service agent
9 Battery error or no signal from
battery
Put the battery in the product correctly
and examine the battery connector. If the
error LED on the battery flashes, see
Battery on page 13
.
The product stops 8 The battery is weak Charge the battery. See
To charge the
battery on page 13
.
0 Battery connector failure Examine the battery connector
18 1680 - 003 - 26.11.2021
Loading ...
Loading ...
Loading ...