Loading ...
Loading ...
Loading ...
BASS GIG
Responsible party name: Rockville
Address: 600 Bayview Ave.
Entrance A
Inwood, NY 11096
Hereby declares that the product(s) Bass Gig series pro audio folded horn speakers com-
ply with FCC rules as mentioned in the following paragraph:
This device complies with Part 15 of the FCC rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment o and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit dierent from that to which the
receiver is connected.
FEDERAL COMMUNICATIONS COMMISSION COMPLIANCE INFORMATION
UNIT FAILS TO POWER UP.
1. Make sure unit is plugged in properly to wall outlet.
2. Check that power cable is plugged in tightly to unit.
3. If people or equipment tend to step and roll over or stretch your power cable it can
get damaged. Always try a second cable to test for shorts in original cable. Dispose of
original damaged power cables immediately.
4. If system still fails to turn on, UNPLUG FROM WALL. There is a small door below the
plug input on the Bass Gig unit, pop o this door and remove the fuse with long
nose pliers and replace with same rated fuse (see diagram below). Please make sure
unit is unplugged from wall before attempting to change the fuse!
UNIT TURNS ON, BUT NO SOUND.
1. Check that all cables are plugged in properly.
2. If using a mixing console make sure fader and balance are set to center positions and
level increased.
Fuse replacement Diagram
Trouble Shooting
Loading ...