Loading ...
Loading ...
Loading ...
11
BP
INPUT
OUTPUT
CH1 CH3
CH2 CH4 RIGHT
LEFT
HIGH LEVEL
INPUT
CLONE
X-OVER
FREQUENCY
MULTIPLIER
FULL
50Hz
500Hz
300Hz
3KHz
MINMAX
HPF X1 X10
CH3 & CH4
+ - GND + -
+ - GND + -
HIGH
PASS
INPUT
LEVEL
LPF / BPF
STATUS
CROSSOVER
INPUT MODE
FULLHPF2CH 4CH
0dB 12dB 15Hz 1KHz 50Hz 3KHz
BASS
EQUALIZER
HIGH
PASS
LOW
PASS
MIN MAX
INPUT
LEVEL
AUTO START
SMART
CIRCUIT
CHANNELS 1-2 CHANNELS 3-4
TO AUDIO OUTPUTS OF HEAD UNIT OR SIGNAL
PROCESSOR WITH STEREO OUTPUTS
If your head unit has 2 pairs of RCA output jacks, input Front Left and Front Right in to Channels 1 and 2. Then attach radio output Rear Left and Rear Right to Channels 3 and 4. Set
the Input Mode Switch to 4Ch position. The pre amp circuitry will not mix any signals thereby preserving full Left to Right Balance and Front to Rear fader control.
Should your head unit have an additional subwoofer
RCA output, that typically needs to be attached to a
separate subwoofer amplier.
When conguring a 4 channel amplier to a 3 channel
system, you can use an RCA Y adaptor to send
the subwoofer preamp signal to channels 3 and 4
and bridge those channels to the subwoofer. Use Y
adaptors to mix channels 1 and 3 and input them in to
RCA Channel 1, then mix channels 2 and 4 and input them in to
RCA Channel 2. The result will be preserved Left and
Right balance with constant subwoofer output.
L L
R R
4 Channel Amp with 4 C hannel Input
INPUT MODE SWITCH
IN 4CH POSITION
Loading ...
Loading ...
Loading ...