Loading ...
Loading ...
Loading ...
4
SYMBOLOGY
Volts
Direct Current
WARNING
Keep hands away from
moving die and ram head
while tool is in use. Fingers could be
crushed, fractured, or amputated.
Lock
Unlock
Shear plane
Lubrication
Tri-stand chain
Read Operator's Manual
UL Listing for Canada and U.S.
ASSEMBLY
WARNING
Recharge only with the charger
specied for the battery. For spe-
cic charging instructions, read the operator’s
manual supplied with your charger and battery.
Removing/Inserting the Battery
To remove the battery, push in the release buttons
and pull the battery pack away from the tool.
WARNING
Always lock the trigger or remove
the battery pack any time the tool
is not in use.
To insert the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
WARNING
Only use accessories specically
recommended for this tool. Others
may be hazardous.
ONE-KEY™
To learn more about the ONE-KEY™ functionality
for this tool, go to milwaukeetool.com/One-Key. To
download the ONE-KEY™ app, visit the App Store
®
or Google Play™ from your smart device.
ONE-KEY™ Indicator
Solid Blue Wireless mode is active and ready
to be congured via the ONE-KEY™
app.
Blinking Blue Tool is actively communicating with
the ONE-KEY™ app.
Blinking Red Tool is in security lockout and can
be unlocked by the owner via the
ONE-KEY™ app.
OPERATION
WARNING
Do not use damaged dies. Using
damaged dies could result in seri-
ous personal injury.
Keep hands away from moving die and
ram head while tool is in use. Fingers
could be crushed, fractured, or amputated.
Always wear proper eye protection marked to
comply with ANSI Z87.1.
When working in dusty situations, wear appro-
priate respiratory protection or use an OSHA
compliant dust extraction solution.
NOTICE
To avoid damage to the tool, do not
operate the tool without the die retain-
ing pin fully inserted and locked into die. Damage
to the cylinder or clevis may occur.
Lubrication
The top and bottom die channel faces (see
"Functional Description") of the strut shear
clevis must remain well lubricated through-
out life to prevent die binding. Regularly
lubricate the top and bottom die channel faces with
a generous amount of Type "E" Grease Cat. No.
49-08-4122. Always lubricate the top and bottom die
channel faces before die installation. If the strut shear
die does not fully retract, closely inspect the clevis
for cracked or broken parts. If no issues are found,
the dies and clevis should be cleaned, re-greased,
and the tool cycled to ensure functionality.
NOTE: If the die gets stuck in the extended posi-
tion, remove battery pack to avoid starting the tool.
Gently tap the die back to the fully seated position,
disengage the return arm, clean out the dies, and
ensure the die channel within the clevis is clean of
debris. Relubricate.
Inserting/Removing Dies
Inspect dies and strut before use. Do not use dam-
aged dies. Using damaged dies could result in
serious personal injury. Only use properly matched
dies. Refer to "Accessories" for die compatibility. To
maximize die life, swap the cutting edge of the dies
periodically.
To insert:
1. WARNING! Remove battery to avoid starting the tool.
2. Pull and hold the return arm outward to slide the
rst die into the stationary pocket.
3. With the return arm still pulled out, insert the sec-
ond die beside the rst.
NOTE: Some die sizes have two die retaining
pin holes. Those dies can be inserted facing up
or down.
Loading ...
Loading ...
Loading ...