Loading ...
Loading ...
Loading ...
黀
ǩ
17. Using Carriage Bolts (PN 19828) and
Nuts (PN 19799) attach all the remaining
Wall Panels (PN 19743) and Corner
Sections (EXCEPT where you want to
bring the door into the Safety Shelter).
Be sure the large round holes are in the
lower flange of each wall and corner
panel. The top flange of the wall and
corner panels will have smaller slotted
holes that will be used to attach the roof
panels. Only finger-tighten all the bolts
between panels and corners at this time.
Be sure to line up each panel and corner
on the lines placed on the floor and over
the anchor bolt holes.
Note: For our application the door was brought in from the
left because there was no access from the right or back.
Your application may be different but the procedure for
installing each panel and corner is the same, no matter the
order or direction.
18. With the help of a second person carry
the preassembled Door into the Safety
Shelter and lean it safely against the
back or side wall of the Safety Shelter.
19. Install the last remaining Wall Section
following the same procedures. Leave all
bolts finger-tight at this time.
26
Loading ...
Loading ...
Loading ...