MODEL 1PHPC7
OWNER’S MANUAL
PERSONAL CERAMIC HEATER
7” | 400W
3
SPECIFICATIONS:
Voltage Rating: 120 V (60Hz) 3.3 Amps
Power Consumption: 400W
IMPORTANT NOTE:
Read the manual carefully. Make sure to save this manual for future
reference. Illustrations in this manual are for explanatory purposes
only, your actual product may look slightly dierent.
CONTENTS
SAFETY INFORMATION ....................................................................................... 4
IN THE BOX ............................................................................................................... 8
PRODUCT DIAGRAM ............................................................................................. 8
INSTRUCTIONS FOR USE .................................................................................. 9
MAINTENANCE ....................................................................................................... 9
STORAGE ................................................................................................................10
TROUBLESHOOTING ..........................................................................................10
SAFETY & PRECAUTIONS
CONTINUEDCONTINUED
4
SAFETY INFORMATION
IMPORTANT INSTRUCTIONS
When using this electric unit, basic safety precautions should always
be followed to reduce the risk of re, electric shock, and injury to
persons, including the following:
1. Read ALL instructions before using this unit.
2. CAUTION: Risk of Electric Shock. DO NOT open or try to repair
the heater yourself.
3. This heater may get hot when in use. To avoid burns,
DO NOT let bare skin touch hot surfaces. If provided, use
handle(s) when moving this heater. DO NOT place it against
walls, furniture, curtains, etc.
4. The output of this heater may vary and its temperature may
become intense enough to burn exposed skin. Use of this heater
is not recommended for persons with reduced sensitivity to heat
or an inability to react to avoid burns.
5. Keep combustible materials, such as furniture, pillows, bedding,
paper, clothes, and curtains at least 3 ft from the front of the
heater and keep them away from the sides, top, and rear.
DO NOT place towels or other objects on the heater.
6. Extreme caution is necessary when any heater is used. DO NOT
leave invalids or children unattended with an operating heater.
DO NOT leave heaters unattended when in use.
7. Always unplug heater when not in use.
WARNING
Read and understand this entire owner’s manual,
including all safety information, before plugging in or using this
product. Failure to do so could result in re, electric shock, or serious
personal injury.
5
SAFETY INFORMATION
8. DO NOT operate any heater with a damaged cord or after the
heater malfunctions, has been dropped, or damaged in any
manner. Discard damaged heater or return heater to authorized
service facility for examination, electrical or mechanical
adjustment, or repair.
9. This heater is not intended for use in bathrooms, laundry areas,
showers or swimming pools and similar locations. NEVER locate
heater where it may fall into a bathtub or
other water container. To protect against electrical hazards,
DO NOT immerse in water or other liquids.
10. DO NOT touch the control panel or plug with a wet hand.
11. DO NOT run cord under carpeting. DO NOT cover cord with throw
rugs, runners, or similar coverings. Do not route cord under
furniture or appliances. Arrange cord away from trac area and
where it will not be tripped over.
12. DO NOT insert or allow foreign objects to enter any ventilation
or exhaust opening as this may cause an electric shock or re
or damage the heater.
13. To prevent a possible re, DO NOT block the air intakes or
exhaust in any manner. DO NOT use on soft surfaces, like a bed,
where openings may become blocked.
14. A heater has hot and arcing or sparking parts inside.
DO NOT use in areas where gasoline, paint, explosive
and/or ammable liquids are used or stored. Keep unit
away from heated surfaces and open ames.
15. To avoid re or shock hazard, plug the unit directly into
a 120 V AC electrical outlet.
16. To prevent overloading a circuit, do not plug the heater
into a circuit that already has other appliances working.
17. It is normal for the plug to feel warm to the touch; however,
a loose t between the AC outlet (receptacle) and plug may
cause overheating and distortion of the plug. Contact a
qualied electrician to replace loose or worn outlet.
(Continued)
SAFETY & PRECAUTIONS
CONTINUEDCONTINUED
6
18. To disconnect heater, turn controls to OFF, then remove plug
from outlet. Pull rmly on the plug, DO NOT unplug by pulling
on the cord.
19. Always unplug the unit before moving or cleaning, or whenever
the heater is not in use.
20. Use only for intended household use as described in this
manual. Any other use not recommended by the manufacturer
may cause re, electric shock, or injury to persons. The use of
attachments not recommended or sold by unauthorized dealers
may cause hazards.
21. Always use on a dry, level surface. Use on oor only.
22. DO NOT use outdoors.
23. WARNING: To reduce the risk of re or electric shock,
DO NOT use this unit with any solid-state speed control device.
24. DO NOT attempt to repair or adjust any electrical or mechanical
functions on this unit. Doing so will void your warranty. The inside
of the unit contains no user service able parts.
25. Always use the product in an upright position.
26. This heater cannot achieve accurate temperature control of the
environment, and thus cannot be used as insulation device for
storage environment, items, animals and plants.
27. Use this heater only as described in this manual. Any other use
not recommended by the manufacturer may cause re, electric
shock, or injury to persons.
CAUTION
Always plug heaters directly into a wall outlet.
Never use with an extension cord or power strip.
SAFETY INFORMATION (Continued)
7
OVERHEAT SAFETY FEATURE
This heater is equipped with an overheat safety feature. When
the heater’s internal components reach a certain temperature
that could cause overheating and possible re, the heater will
automatically shut o.
• A thermal overload protector is built in to prevent overheating.
When an “overheat” temperature is reached, the heater will
automatically shut o. Operation can resume only when the user
resets the unit.
• To reset the unit, unplug the heater, ensure the power is turned o,
and
wait 15 to 20 minutes for the unit to cool down.
• Follow OPERATING INSTRUCTIONS to return heater to operating
mode.
WARNING
It is normal for the power cord to feel warm to the touch; however,
a loose t between the outlet and the plug may cause overheating of
the plug. If this occurs, try inserting the plug into a dierent outlet.
Contact a qualied electrician to inspect the original outlet for damage.
SAFETY INFORMATION (Continued)
SAFETY & PRECAUTIONS
CONTINUEDCONTINUED
8
PRODUCT DIAGRAM
IN THE BOX
• COMPACT CERAMIC HEATER • OWNER’S MANUAL
9
INSTRUCTIONS FOR USE
1. Place the product on a rm, level surface.
2. With the POWER SWITCH in the OFF position,
plug the unit directly into a 120 V AC electrical outlet.
3. Turn the POWER SWITCH to ON position.
4. Turn the POWER SWITCH to OFF and unplug the heater
when nished using.
WARNING
• DO NOT let liquid enter the heater.
• DO NOT use alcohol, gasoline, abrasive powders, furniture polish,
or rough brushes to clean the heater. This may cause damage or
deterio ration to the surface of the heater.
• DO NOT immerse the heater in water.
MAINTENANCE
1. Turn POWER SWITCH to the OFF position.
2. Unplug the unit and let it cool completely.
3. To keep the heater clean, the outer shell may be cleaned with
a soft, damp cloth. A mild detergent can be used if necessary.
4. After cleaning, dry the unit with a soft cloth.
5. Wait until the unit is completely dry before use.
SAFETY & PRECAUTIONS
CONTINUEDCONTINUED
10
STORAGE
TROUBLESHOOTING
Store the heater in a cool, dry location when not in use. To prevent
dust and dirt build-up, use the original packaging to repack the unit.
If the heater will not operate, please check the following before
seeking repair of service:
1. Check if the power cord is plugged into an electrical outlet.
If not, plug in unit to appropriate outlet.
2. Check if electricity to the outlet is working.
3. Ensure power is turned to ON position.
4. Make sure heater is placed on a at, solid surface.
5. See SAFETY FEATURES section for additional information.
844-4PA-AIRE | 844-472-2473 | support@perfectaire.us
CANADA SUPPORT 877-997-2473 | supportcanada@perfectaire.us
www.perfectaire.us
5401 Dansher Road
Countryside, IL 60525
Printed in China | 0522_M899
