Loading ...
Loading ...
Loading ...
- 13 -
8. PREPARING THE DRILL
FIG.1
FIG.2
8.1 BATTERY PACK CHARGING –
FIGS.1–2
This power product is either supplied “bare”, without
battery pack or charger (Stock No.55519), or with a
transformer/charger and one battery pack (Stock
No.00594).
Important: Only Draper designated battery packs and
chargers can be used in conjunction with this product.
Use of any other third party battery packs/chargers
with this product is considered misuse and will
invalidate the product’s warranty.
Once connected to the mains supply, recharging of
the battery can be left generally unsupervised,
requiring minimal attention. Complex circuit
construction monitors the battery condition, adjusting
the recharge current to suit. When the recharge cycle
is complete, to maintain the full capacity, a low output
current will continue as required.
Warning! Check the condition of the charger and
battery prior to each charge. If there is any sign of
damage then do not commence charging, seek advice
from Draper Tools.
The battery pack is supplied un-charged and must be
charged before initial use.
To charge the battery pack , it must first be
removed from the tool.
To release the battery pack:
– Press the battery release button and gently
slide the battery pack off (Fig.1).
– Plug the battery charger unit into a 230V/AC
13amp three pin supply socket.
– The red LED will illuminate to show the
charger has power.
– Slide the battery into the charger (the battery is
shaped to fit into the charger one way only.
– After a few seconds delay, the red LED will
flash to show that charging has begun, then
illuminate solid red.
– Whilst the battery is charging, the green LED will flash, (the red LED will go from flashing to
constant red.
– When the battery is fully charged when the green LED stops flashing and remains a constant
green. The red LED will extinguish.
Caution: Do not pull the plug out of the power supply by pulling on the cord. Make sure to grasp the
plug when removing from power supply to avoid damaging the cord.
To remove the battery from the battery charger:
– Supporting the battery charger with hand, pull out the battery from the battery charger.
Caution: If the battery charger has been in continuous use it will be hot. Once the charging has been
completed, leave the charger 15 minutes to cool until next use.
Loading ...
Loading ...
Loading ...