Loading ...
Loading ...
Loading ...
36
For extractor mode operation:
• Connect a flexible extractor tube (not supplied) with an inside diameter of Ø 150 mm to
the connection element.
• Slide the inner (upper) duct along the slide fitting, into the outer (lower) duct. Check that
the inner duct lines up with the top ventilation holes.
• Determine the length of the duct cover extension by pulling the inner duct up or sliding it
back into the outer duct.
• Attach the mounting rail to the upper end of the duct.
Drill two Ø8 mm holes in the wall and place the dowels. Use 2 ST4*35mm screws to fix the
rail.
For extractor mode operation:
• Check that the flexible exhaust pipe is in the correct position and connect it to the
exhaust outlet to the outside.
• Pull up the inner duct cover and fix the duct unit on the previously mounted rail side by
screwing 2 x ST4*10 mm screws.
Activated carbon filter installation for recirculation mode
• Remove the lid and the aluminum grease filter
• Place the charcoal filter over the air inlet of the extraction duct. Check that the extraction
duct mounting studs fit into the charcoal filter mounting slots. Turn the respective filter
clockwise until it clicks into place.
• Replace the aluminum grease filter and close the lid.
Loading ...
Loading ...
Loading ...