Loading ...
Loading ...
Loading ...
14
OPERATION
HOLDING THE UNIT
• Stand in the operating position (Fig. 15). Stand up straight. Do
n
ot bend over.
• Keep feet apart and firmly planted.
• Hold the shaft grip with the right hand. Keep the right arm
slightly bent.
• Hold the handle with the left hand. Keep the left arm straight.
• Hold the unit at waist level.
• Position the cutting head a few inches above the ground.
WARNING:
Always wear eye, hearing, hand, foot and
body protection to reduce the risk of injury when operating
this unit.
WARNING:
To prevent serious personal injury, avoid arm
c
ontact with the engine while operating the unit. The
engine may be extremely hot.
Fig. 15
ADJUSTING THE TRIMMING LINE LENGTH (BUMP HEAD)
This unit is equipped with a bump head. Trimming line can be
released from the cutting head without stopping the engine.
To release more line, lightly tap the bump knob on the ground (Fig. 16)
while operating the unit at high speed. For best results, tap the bump
knob on bare ground or hard soil. Attempting to release line in tall
grass may stall the engine.
NOTE: Do not rest the cutting head on the ground while the unit is
running.
Each time the bump knob is tapped, about 1.5 inches (38 mm) of
trimming line is released.
NOTE: Always keep the trimming line fully extended. Line release
becomes more difficult when the cutting line gets shorter.
A blade in the cutting head shield will cut the line to the proper
length if any excess line is released.
WARNING:
Do not remove or alter the line cutting blade
assembly. Excessive line length will make the unit
overheat. This may lead to serious personal injury or
damage to the unit.
Fig. 16
Bump Knob
TIPS FOR BEST RESULTS
• To direct clippings away from the operator, tilt the cutting head
slightly down to the right; cut from left to right whenever possible.
• Do not trim wet grass or weeds.
• When Using the Aero-Flex® Head: To improve performance and
maximize the life of the line blades, operate the unit at the
recommended speed when performing particular tasks:
• Trimming - Operate the unit at higher speeds.
• Decorative Trimming (against fences or other hard objects) -
Operate the unit at lower speeds.
• Edging - Operate the unit at lower speeds.
Loading ...
Loading ...
Loading ...