Loading ...
Loading ...
Loading ...
6
Important: Once you are ready to install the ice maker in a cabinet or directly on the floor,
you must adjust the feet to level the ice maker. If the floor is level, just rotate the two front
feet to touch the floor.
Important: Before you begin, unplug the ice maker or disconnect the power.
Leveling the Ice Maker
It is important for the ice maker to be leveled in order to work properly. It
can be raised or lowered by rotating the four rubber feet on the bottom of
the machine. If you find that the surface is not level, rotate the feet until the
ice maker becomes level. You may need to make several adjustments to
level it. We recommend using a carpenter’s level to check the machine.
1. Place a carpenter’s level on top of the product to check if the ice
maker is level from front to back and side to side.
2. Adjust the height of the feet as follows:
Turn the leveling feet to the right to lower that side of the ice maker.
Turn the leveling feet to the left to raise that side of the ice maker.
Reversing the Door Swing
Tools needed: flathead screwdriver, Phillips screwdriver
1. Using a flathead screwdriver, separate the hinge axis from top hinge.
2. Remove the three screws securing the top hinge to the cabinet. Remove the plug
buttons opposite the top hinge. Place hinge, screws, plug buttons and hinge axis
safely aside.
3. Open the door about 20 degrees, then lift the door off the bottom hinge 2 and set the
door aside.
4. Remove the three screws securing the bottom hinge to the cabinet and the plugs
opposite.
5. Rotate the door 180 degrees from its original position. The handle should be opposite
the door hinges.
6. Replace the original top hinge on the opposite side at the bottom and the original
bottom hinge on the opposite side at the top.
7. Install the hinge axis back through the bottom hinge. Gently place the door on the
bottom hinge and open it approximately 20 degrees.
8. Install the top hinge axis and tighten firmly. Replace all plug buttons.
Loading ...
Loading ...
Loading ...