Loading ...
Loading ...
Loading ...
32
Complete Control
MX-1400
Owner’s Manual
Table of Contents
Specifications
These are the technical specifications for the MX-1400:
Microprocessor: ARM Cortex-M7 Core 600MHz
Memory: 64MB NOR Flash Memory
RAM: 32MB SDRAM
Wi-Fi: 802.11 a/b/g/n/ac
LCD: 240 x 320, 2.4” TFT LCD with C-Touch module
Photo Diode: SMD TYPE x 2EA
IR: SMD TYPE x 2EA
IR Range (Line of Sight via Infrared): 30 to 50 feet, depending on the
environment
RF Range (Radio Frequency): 50 to 100 feet, depending on the environment
Microphone: 2 Ch
Speaker: Mono 1.5W x 1
Battery: Lithium Polymer, 3.7V, 1960mAh
Battery Charging Time: 2.5 Hours
Power: 5.0V 2.0A
Operating Temp: 0~40 ℃
Size: 220 X 50 X 23.8 (mm)
Product Weight: 176.7g (with battery loaded)
Cradle Weight: 139.8g
Warning!
The manufacturer is not responsible for any Radio or TV interference caused
by unauthorized modifications to this equipment.
Changes or modifications not expressly approved by the manufacturer could
void the user's authority to operate the equipment.
Limited Warranty Statement
https://www.urc-automation.com/legal/warranty-statement/
End User Agreement
The terms and conditions of the End User Agreement available at
https://www.urc-automation.com/legal/end-user-agreement/ shall apply.
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Loading ...