Loading ...
Loading ...
Loading ...
14
OPERATING INSTRUCTION
Mounting the Extraction Adapter
Before any work on the power tool, remove the battery. Fasten the extraction adapter to the dust port
without tools.
The extraction adapter may not be mounted when no external dust extraction is connected.
Otherwise the extraction channel can become clogged.
Do not connect a dust bag to the extraction adapter.
Otherwise the extraction system can become clogged. To ensure optimum extraction, the extraction
adapter must be cleaned regularly.
Adjusting the Cutting Depth
Adjust the cutting depth to the thickness of the work-piece. Less than
a full tooth of the blade teeth should be visible below the workpiece.
Loosen wing bolt. For a smaller cutting depth, pull the machine from
the base plate; for a larger cutting depth, push the machine toward
the
base plate.
Adjust the desired cutting depth at the cutting-depth scale.
Tighten wing bolt again. When setting the cutting depth, use the
reference mark to the side of the cutting-depth scale.
Adjusting the Cutting Angle
It is best to place the machine on the face side of the blade guard.
Loosen wing bolt.
Tilt the saw side-wards.
Adjust the desired setting at the scale.
Tighten wing bolt again.
Note: For bevel-cuts, the cutting depth is smaller than the setting indicated
on the cutting-depth scale.
Switching On and Off
To start the machine
First push the lock-off button for the On/Off switch.
Then press the On/Off switch and keep it pressed.
When cut the wood, put the machine on the workpiece and push it along the wood.
To switch off the machine
First take out of the machine from workpiece.
Then release the On/Off switch.
Note: For safety reasons, the On/Off switch cannot be locked; it must remain pressed during the entire
operation.
Fig.5
Fig.4
Loading ...
Loading ...
Loading ...