Troy-Bilt 24A-07MM066 Chipper Shredder Vacuum Model

Operator’s Manual - Page 7

For 24A-07MM066.

PDF File Manual, 40 pages, Read Online | Download pdf file

24A-07MM066 photo
Loading ...
Loading ...
Loading ...
Gray Cap
Insert the cap/dipstick into the oil filler neck, but do not 2.
screw it in. See Fig. 3-3.
Remove the oil filler cap/dipstick. If the level is low, slowly 3.

Fig. 3-2.
Replace and tighten cap/dipstick firmly before starting 4.
engine.
NOTE: Do not overfill. Overfilling with oil may cause
smoking, hard starting, spark plug fouling, or oil saturation
of air cleaner.
Yellow Cap
Remove the oil filler cap/dipstick and wipe the dipstick 1.
clean.
Insert the dipstick into the oil filler neck. Turn the dipstick a 2.
1/4 turn into the locked position to fully seat. See Fig. 3-3.
If the level is low, slowly add oil to the upper limit on the 3.
dipstick. See Fig. 3-2 inset.
Reinsert the dipstick into the locked position before 4.
starting the engine.
NOTE: Do not overfill. Overfilling with oil may cause
smoking, hard starting, spark plug fouling, or oil saturation
of air cleaner.

  Cap
Fuel Requirements
Operating the engine with E85 fuel, an
oil/gasoline mixture, dirty gasoline, or gasoline over
30 days old without fuel stabilizing additive may
result in damage to your engine’s carburetor.
Subsequent damage would not be covered under
the manufacturer’s warranty.
Use automotive gasoline (unleaded or low leaded to minimize
combustion chamber deposits) with a minimum of 87 octane.


dirty gasoline. Avoid getting dirt, dust, or water in the fuel tank.

Gasoline is extremely flammable and is
explosive under certain conditions.
Refuel in a well-ventilated area with the engine stopped. 
Do not smoke or allow flames or sparks in the area where
the engine is refueled or where gasoline is stored.
Do not overfill the fuel tank. After refueling, make sure the 
tank cap is closed properly and securely.

fuel vapor may ignite. If any fuel is spilled, make sure the
area is dry before starting the engine.
Avoid repeated or prolonged contact with skin or 
breathing of vapor.
Adding Fuel
An adult should fuel this engine. NEVER
allow children to refuel its engine. Gasoline (fuel)
vapors are highly flammable and can explode. Fuel
vapors can spread and be ignited by a spark or flame
many feet away from engine. To prevent injury or
death from fuel fires, follow these instructions:
DO NOT use leaded fuel.
Fuel must be fresh and clean. NEVER use fuel left over 
from last season or stored for long periods.
NEVER mix oil with fuel.
DO NOT use fuel containing Methanol (Wood 
Alcohol)
NOTE: 
Clean around fuel fill before removing cap to fuel.1.
Fill tank until fuel reaches 2. ⁄ inch below the bottom of the

to overfill.
Replace the gasoline cap and tighten securely. Wipe up 3.
spilled fuel before starting engine. If fuel is spilled DO NOT
start engine. Move machine away from area of spillage.
Avoid creating any source of ignition until fuel vapors are
gone.
7se c t i O n 2 — se t -up
Loading ...
Loading ...
Loading ...