Loading ...
Loading ...
Loading ...
DS-K1107A Series Card Reader • User Manual
6
Steps for Wiegand communication mode:
Set the DIP switch of No. 6 as 1.
Set the DIP switch of No. 5 and 7 for reading card mode and Wiegand protocol. For details,
please refer to 2.1 Introduction for DIP Switch.
Wiring the cable between controller and card reader as shown below.
Yellow
Blue
Black
Red
Black
Red
Green
White
Purple
Orange
Brown
Controller
Card Reader
Yellow
Blue
Black
Red
Black
Red
Green
White
Purple
Orange
Brown
Controller
Card Reader
Card Reader
Card Reader
Green
Wiring for Wiegand Communication Mode
Installing Card Reader
Before you start:
Set the DIP switch. For details, refer to 2.1 Introduction for DIP Switch.
Installation for DS-K1101/ 02/ 03/ 04 series card reader:
Fix the plate on the wall or other places by using two screws (PA4×25-SUS). Make sure the
arrows on the plate are upwards.
Check whether the plate is fixed and in the right direction.
Slide the card reader from the direction A to B along the plate side until the bottom matches
the joint. Make sure the card reader is tightly on the wall or other places.
Drag and move the card reader to make sure it is fixed
Loading ...
Loading ...