Loading ...
Loading ...
Loading ...
RIGOL Chapter 1 Quick Start
1-8 MSO2000A/DS2000A User’s Guide
Probe Compensation
When the probes are used for the f irst time, you should compensate the probes to
match the input channels of the oscilloscope. Non-compensated or poorly
compensated probes may cause measurement inaccuracy or error. The probe
compensation procedures are as follows.
1. Perform steps 1, 2, 3 and 4 of “Function I nspection”.
2. Check the displayed waveforms and compare them with the following figures.
Figure 1-9 Probe Compensation
3. Use a nonmetallic driver to adjust the low-frequency compensation adjustment
hole on the probe until the displayed waveform is as the “Perfectly
compensated” in the figure above.
Over compensated Perfectly compensated Under compensated
Loading ...
Loading ...
Loading ...