NXR AK4807LP Culinary Series 48 Inch Freestanding All Gas Range with Liquid Propane Gas, 6 Sealed Burners, Griddle, Double Ovens, 7.2 cu. ft. Total Oven Capacity, Convection Oven, Viewing Window, Continuous Grates, Gliding Rack, Sealed Burners, Conti

User Manual - Page 27

For AK4807LP.

PDF File Manual, 30 pages, Read Online | Download pdf file

AK4807LP photo
Loading ...
Loading ...
Loading ...
Troubleshooting
Before you call for service,please review the potential problem/possible causes
and remedies shown in the table below.
Nothing works
Oven is not connected to the
electrical power.
Power supply is not energized.
Have oven connected to a
properly sized electrical power
supply by a qualified electrician.
Have an electrician check the
power supply, including the
house circuit breaker,wiring and
fuses
Top burners do
not light or do not
burn evenly
Plug on range is not completely
inserted in the electrical outlet.
Burner holes on the side of the
burner may be clogged.
Make sure the unit is properly
connected to the power supply
Remove the burner heads and
clean them. Check the electrode
area for burned-on food or grease.
Burner flames
very large and
yellow.
Burner bezel ports are clogged.
Burner ports or burner caps are
not positioned properly.
Cooktop is being operated with
the wrong type of gas.
Regulator is not installed, is
faulty, or is set for the wrong
type of gas.
Clean burner bezel ring ports
with straightened paper clip,
needle,or wire.
Remove and carefully re-install
burner bezel and caps.
Ensure that the type of cooktop
matches the natural gas supply.
Check installation,replace
regulator,or set regulator for
proper gas.
Sparking but no
flame ignition.
Gas shut-off valve is in the „OFF
position.
Turn shut-off valve to the „ON‟
position.
Igniters spark
continuously after
flame ignition.
Power supply polarity is reversed.
Igniters are wet or dirty.
Have polarity corrected.
Dry or clean igniters.
Burner flame
goes out at low
setting.
Low gas supply pressure.
Air intake holes around knobs
are obstructed.
Contact gas company.
Remove obstruction.
Oven will not
heat
Oven settings are not corrected
Follow mode selection and clock
settings as specified in Oven
Operation section of the manual.
Foods over-
cooked or under-
cooked
Incorrect cooking time or
temperature.
Adjust time,temperature,or rack
position.
„Cracking‟ or
„Popping‟ sound.
This is the sound of metal
heating and cooling.
This is normal.
27
Loading ...
Loading ...
Loading ...