Loading ...
Loading ...
Loading ...
13 14
0800 862 0453 sharkclean.eu
CARING
FOR YOUR Steam mop
AFTER USE AND STORAGE
1 Press the Steam Control Button until
the three lights below start to blink,
indicating that you are in Standby
mode. Unplug the cord from the outlet
and place the steam mop into the
upright position. Let it cool.
2 To remove the Dirt Grip™ pad, lift
the steam mop straight up by the
handle until the Klik n' Flip® Mop Head
is hanging straight down. Press the
Release button on the back of the
steam mop body, and both sides of the
Klik n' Flip® Mop Head will drop open,
releasing the pad. Once the pad has
been released, close the Klik n' Flip®
Mop Head.
3 If the Klik n' Flip® Mop Head is not
attached to the mop, the pad can
still be removed. Press the two red
secondary pad release buttons located
on the sides of the Klik n' Flip® Mop
Head post to release the pad. (fig. 12)
4 Empty the water tank before storing.
To empty the tank, hold the steam mop
beside a sink. Open the water tank lid,
then lean the unit over the sink. Let the
water drain out, then close the lid.
5 To store the steam mop, wait until
after it has cooled and the steam has
been released. Then remove the Klik
n' Flip® Mop Head and hang the steam
mop by its handle on a large hook (not
included). (fig. 13)
6 Store the filling flask by attaching it to
the top handle pole of the steam mop.
CARING
FOR YOUR Steam mop CONTINUED
FIG.12
FIG.13
FIG.14
FIG.15
DIRT GRIP PAD CARE INSTRUCTIONS
Care
Machine-wash the Dirt
Grip pads separately
with warm water using liquid detergent.
NEVER USE BLEACH, POWDERED
DETERGENT, OR FABRIC SOFTENERS
as they may damage or leave a coating on
the Dirt Grip pads that will reduce
their
cleaning performance and absorbency.
Dirt Grip pads should be line-dried or
tumble-dried on a low setting, as this will
extend the life of the microfiber fabric.
(fig. 14)
L
oose fibers can indicate wearing of the
microfiber fabric. Do not pull the loose
fibers, as this can cause the weave to come
undone. Simply trim the loose fibers with
scissors. (fig. 15)
Replacement Dirt Grip pads
For best cleaning results, we recommend
replacing your Dirt Grip pads every 3 to 4
months following normal use. As with any
fabric, dirt particles, grease, friction, and
repeated washing can cause the fibers to
break down, and you may notice an increase
in the eort needed to push or pull
the steam mop.
You can purchase replacement Dirt Grip
pads and other accessories by visiting
sharkclean.eu or calling 0800 862 0453.
STEAM NOZZLE CARE
If you believe the main steam nozzle or the
Steam Blaster™ nozzle is clogged, please
contact Customer Service on
0800 862 0453 or www.sharkclean.eu/uk
REPLACEMENT PARTS
To replace accessories please contact Shark
Customer Service on 0800 862 0453 or
www.sharkclean.eu/uk.
Loading ...
Loading ...
Loading ...