Loading ...
Loading ...
Loading ...
9 10
0800 862 0453
sharkclean.co.uk
USING
YOUR STEAM MOP
IMPORTANT: Make sure
you do not use the steam
mop without attaching a
Dirt Grip™ pad and adding
water to the water tank
first. When you are using
the steam mop for the
first time, it might take
longer than the normal 30
seconds to start steaming.
IMPORTANT: Do not use
on unsealed wood or
unglazed ceramic floors.
On surfaces that have
been treated with wax
and on some no-wax
floors, the sheen may
be removed by the heat
and steam action. Test
an isolated area of the
surface to be cleaned
before proceeding.
Check the care and use
instructions from the
floor manufacturer.
CAUTION: While in Steam
Blaster mode, do not leave
stationary for more than
one minute.
CAUTION: Do not scrub
any one area for an
extended period of time.
6 To stop the Steam Blaster spray,
simply raise the handle. You can
then flip the mop head back into
its original position and continue
cleaning.
7 When you have finished mopping,
press the Steam Control Button. The
three blue lights will blink, indicating
that the unit is in Standby mode.
Once in Standby mode, unplug the
unit.
8 To remove the Dirt Grip™ pad, simply
lift the steam mop straight up by
the handle until the Klik n' Flip® Mop
Head is hanging straight down. Press
the Release button on the back of
the steam mop body (fig 10a), and
both sides of the head will drop open,
releasing the pad. (fig 10b)
9 Once the Dirt Grip pad has been
released, close the Klik n' Flip® Mop
Head. To close, gently press one side
of the Klik n' Flip® Mop Head to the
floor until that side clicks into place.
Repeat on the other side.
10 When the water tank is empty, the
steam mop will stop producing
steam. You can refill the water tank
at any time as long as the steam mop
is unplugged. Follow the water tank
filling instructions on page 8.
1 Twist the Quick-Release Cord Holder to unwrap
the power cord completely. (fig. 9) Plug into an
electrical outlet.
2 When it's first plugged in, the unit will be in
Standby mode. The 3 lights below the
Steam Control Button will blink to indicate
Standby mode.
3 To select the steam mode, press the Steam
Control Button once for LOW (1 blue light) twice
for MED (2 blue lights) or three times for HI
(3 blue lights).
4 Clean your floors with a forward and
backward motion.
5 When you need an extra burst of steam to clean
a stuck-on stain, you can use the Steam Blaster™
feature. Flip the head over so that it is behind the
mop body, then tilt the mop handle down. This
will cause the Steam Blaster (fig. 10) to emit
a concentrated blast of steam onto the stain.
NOTE: Please wait 2 to 3 minutes
for the steam mop to cool o before
switching the mop head. Never leave
the steam mop with a damp/wet Dirt
Grip pad on any floor for an extended
period of time.
FIG.8 FIG.9
FIG.10A
FIG.10B
TIP: To prolong the life
of your steam mop,
we recommend using
distilled water.
TIP: Sweep or vacuum
your floors prior to
cleaning with your
steam mop.
Loading ...
Loading ...
Loading ...