Loading ...
Loading ...
Loading ...
TROUBLESHOOTING
If the machine breaks down, please wait for the machine to stop automatically. You can
solve the problem by using the method in the table below. But don't disassemble, inspect
or repair the machine without professional guidance.
Tip: After power-on, the water tank is turned over to deicing state, the ice display lamp
flickers, and the machine enters standby state. Touch the “ ”, then the ice display lights
will continue to light, no longer flicker, the machine into normal working state.
This machine has self-checking function. If an error occurs, the ice-filled and water-
shortage indicator will flicker alternately, and the ice maker will stop working.
Fault phenomenon
No power
Equipment does not respond
Not powered
Check the power supply
Check the power cord connection
Check the power cord for damage
Call authorized technician repair
There is no power in the power jack
The power cord is not plugged in firmly
Power cord is damaged
Cause of issue Solution
IF HAVE STRANGE SMELL
If the ice has a strange taste.If the ice has a disgusting or mildewy odor in the machine,
use the above steps to clean the inside of the machine.
* Add ice-making water, run the ice maker and discard the ice cubes produced four times
before. Then remove the remaining water from the drain and reinstall the drain plug to
ensure that the plug is in place.
* Re-use clean, soft cloth to clean the remaining watermarks. Finish cleaning.
Add water indicator light
Ice full indicator light
Ice cubes stuck together
Ice making environment temperature
or water temperature is too low
Evaporator deformation, sagging
Add water to increase the
temperature of ice making water
Push up the icicles with your hand
Ice full
Ice full induction
Ice full sensor is bad Call authorized technician repair
Lack of water or too little water
Restart after 2 minutes of power
failure
Please add water
Call authorized technician repair
Please take out the ice cubes
Cleaning induction probe
Call authorized technician repair
Poor water insensitivity
The pump is stuck or damaged
Water shortage sensor is bad
HOW TO STORAGE
If the ice maker is not used for a long time, cut off the power supply and remove the
remaining water from the drainage outlet. Dry the interior with a clean soft cloth
(refer to maintenance and cleaning)
This sign “ ” on the product or packaging indicates that the product cannot be treated
as household waste. Should be delivered specific recycling points for electronic and
electrical products. Proper handling of this product can help prevent environmental
problems caused by improper handling of this product and harm to human health. If you
need more details about recycling, please contact the office responsible for household
waste disposal services or the manufacturer or purchase point that purchases our
products.
Warning:
Don’t touch the power supply with wet hands !
Don’t pull out the machine by pulling the power cord !
- 10 - - 11 -
Loading ...
Loading ...