96110 Instruction Manual

Loading ...

12 13

Lubricating the Blade

To Use the Water Tray

1. Ensure the drain plug (A, Fig. 16) is securely inserted into

the drain and the locking wing nut (B, Fig. 16) is tight.

2. Attach the free end of the water hose into the outlet

nipple (C, Fig. 17) on the submersible pump (14).

3. Place the pump in the bottom of the water tray and

firmly press down so that the suction feet are securely

adhered.

4. Secure the slack in the water hose and pump’s power cord

to the tool using the provided snap ties (D, Fig. 17).

5. Fill the water tray to a level that completely covers the

pumplter/intake.

Moving or repositioning saw requires two people, one at each end of main frame.

Saw arm assembly is heavy. Make sure saw arm assembly is separately supported, or main frame will be

unbalanced when lifting saw. Use leg muscles to raise and lower main frame to minimize risk of injury.

Whenrepositioningsawonnewsurface,rstremovemainframefromstand.Thensetupstandsecurelyinlevelpositionatdesired

location on stable surface that will support stand, tray and contents before placing main frame on stand.

Check to make sure saw mounts are properly centered on stand rails before operating saw.

Failure to comply with the following the warnings may result in serious personal injury.

READ ENTIRE MANUAL. In addition to reading these operating instructions, it is important to read and understand the entire

manual before operating this saw. Follow all applicable instructions regarding assembly, preparation, and adjustment prior to

making any cuts and comply with all safety rules and warnings in this section and elsewhere throughout this manual.

Lackofcoolingwatermaydamagetheblade.Toensureproperoperation,theremustbeaconstantowofwater

onto the blade.

Therearetwowaystoensureaconstantowofwatertotheblade:

•bythewatertray •byusingallbucket

MOVING AND STORING TILE SAW

OPERATION

NOTE: In order to ensure safe operation of the pump, remove

the inlet cover on the face of the pump and check to make

sure that the entire circular opening of the inlet is underwater.

NOTE: Failure to ensure the pump is adequately submerged

will cause the pump to burn out, preventing the cooling

mechanism from working properly. When using the water tray

as the source of water, always check to make sure that the

pump is always fully immersed in the water tray.

Figure 16

Figure 17

Loading ...

Delta 96110 10 In. Cruzer Wet Tile/stone Saw