Loading ...
Loading ...
Loading ...
12
6. Reinstall the spindle sheaves belt guard with the self
tapping screws removed earlier.
7. Make certain that the drive belt is on the engine
flywheel pulley and idler pulleys, and retighten the
flange lock nut on the top of the frame.
IMPORTANT: Make certain that the drive belt is seated
correctly and that it is riding smoothly on the spindle
sheaves and is not pinched between them. Repeat the
first three steps if the belt is pinched.
WARNING: Never operate the edger
without the spindle sheaves belt guard
in place.
7
Off-Season
Storage
WARNING
Never operate the
edger without the
spindle sheaves belt
guard in place.
4. Carefully remove the belt from off of the pulleys,
again making sure to note the orientation of the belt.
Discard the belt.
Install the replacement belt (Part No. 754-04032B) in the
same configuration that the original belt was routed as
follows:
5. Working from the front of the edger, place the
belt onto the spindle sheaves, route it back
onto the two idler pulleys, and then place it
onto the engine flywheel pulley.
IMPORTANT: Make certain that the “V” side of the belt
is seated into the top pulley and the flat side of the belt is
seated into the bottom pulley. See Figure 15.
Off-Season Storage
Observe the following when preparing the edger for
long-term storage:
1. Clean and lubricate unit thoroughly as instructed on
page 11 of this manual.
2. Refer to the Engine Manual packed separately with
the edger for engine manufacturers’s storage instruc-
tions.
3. Coat the edger blade with chassis grease to prevent
rusting and corrosion.
4. Store the edger in a dry, clean area. Do not store next
to any corrosive materials, such as lawn fertilizer.
5. Coat the edger, especially any springs and bearings
with a light oil or silicone spray.
IMPORTANT: When storing any type of power equip-
ment in an poorly ventilated or metal storage shed, care
should be taken to rustproof the equipment.
NOTE: Specifications are
subject to change without
notification or obligation.
Images my not reflect your
exact model and are for
reference purposes only.
Loading ...
Loading ...
Loading ...