Loading ...
(2)
Ready H
2
ot® HOT WATER DISPENSER
COMPONENTS:
When you purchase the Ready Hot Water tank, contents include:
1. Quick-connect fi tting for water inlet tube
2. Tank
3. 1/4” or 3/8” Hose Clamp
4. Connector/Reducer adapter for 1/4” or 3/8” center outlet tubing
TYPE OF FAUCET REQUIRED
Only use an “open vent” faucet with the hot water dispenser. Using a standard or reverse type faucet will
damage the tank and void the warranty.
PRESSURE FREE HOT WATER DISPENSER CONCEPT
Unlike other household water dispenser, this dispenser tank is not pressurized for safety reasons. For a
conventional household water heater, the faucet valve is placed after the heater tank resulting in a pressurized
tank. For a hot water dispenser, the faucet valve is placed before the tank, creating an “open vent” style faucet
and consequently no pressure is built up inside the tank.
MATERIAL REQUIRED (NOT PROVIDED)
1. Shut-off valve and T-union fi tting
2. Two mounting bracket screws and plastic support (if attaching to dry wall)
3. 1/4” (6.35mm) O.D. inlet tubing (for areas with freezing climate)
4. Ruler or measuring tape
5. Pliers
6. Hand or electric drill
7. Small drill bit for starter holes
8. 35mm drill bit - if no sink hole exists
9. Gloves
10. Safety glasses
11. Open end wrench
12. Drip pan or bucket
13. Quick Connect fi tting for a cold water supply line
IMPORTANT INFORMATION
This hot water dispenser produces instant hot water of approximately 190°F (88°C) ±5° as dispensed from
the faucet. This product is not intended to produce a continuous fl ow of hot water. This model will produce
up to 60 cups of water per hour at approximately 190°F (88°C) ±5°. Due to high water temperature, for safety
reasons, the tank is not under pressure. Consequently, there is a slight delay of water fl ow after the faucet has
been turned on. This is normal and indicates that the priming chamber is functioning properly.
Loading ...
Loading ...
Loading ...