Loading ...
Loading ...
Loading ...
2.12.2 Auto-Tracking
Steps
1.
Go to Conguraon → EPTZ .
2.
Check Enable EPTZ.
3.
The default Stream Type is Third Stream and cannot be congured.
4.
Select Auto-tracking in Applicaon.
5.
Click Detecon Area to start drawing.
6.
Click on the live video to specify the four vertexes of the detecon area, and right click to
complete drawing.
7.
Set rules.
Detecon Target
Human and vehicle are available. If the detecon target is not selected, all the detected
targets will be tracked, including the human and vehicle.
Note
Only certain camera models support this funcon.
Sensivity
It stands for the percentage of the body part of an acceptable target that is tracked.
Sensivity = 100 - S1/ST × 100. S1 stands for the target body part that enters the pre-dened
area. ST stands for the complete target body. The higher the value of sensivity is, the more
easily the target can be tracked.
8.
Click Save.
2.13 Image Stching
You can switch the video output mode for the camera according to your actual demand.
Steps
Note
●
The funcon is only supported by certain device models.
●
The actual video output mode varies according to dierent models. The actual model prevails.
1.
Go to Conguraon → System → System Sengs → Image Stching .
2.
Select the desired video output mode.
Panorama +
ePTZ
One stched panoramic image (8 MP) and mulple channels ePTZ images.
Channel 01 is the 8 MP panoramic image, and channel 02 and the subsequent
channels are ePTZ images. You can set the number of the channels for the
ePTZ image. Ten channels are available. For example, if you set the number of
Network Camera User Manual
95
Loading ...
Loading ...
Loading ...