Loading ...
Loading ...
Loading ...
175
The following table describes the labels in this screen.
21.5 Classifier Example
The following screen shows an example where you configure a classifier that identifies all traffic
from MAC address 00:50:ba:ad:4f:81 on port 2.
After you have configured a classifier, you can configure a policy (in the Policy screen) to define
action(s) on the classified traffic flow.
Table 74 Advanced Application > Classifier > Classifier Configuration > Classifier Global Setting
LABEL DESCRIPTION
Match
Order
Select manual to have classifier rules applied according to the weight of each rule you configured
in Advanced Application > Classifier > Classifier Configuration.
Alternatively, select auto to have classifier rules applied according to the layer of the item
configured in the rule. Layer-4 items have the highest priority, and layer-2 items has the lowest
priority. For example, you configure a layer-2 item (VLAN ID) in classifier A and configure a layer-
3 item (source IP address) in classifier B. When an incoming packet matches both classifier rules,
classifier B has priority over classifer A.
Logging
Active Select this to allow the Switch to create a log when packets match a classifier rule during a
defined time interval.
Interval Select the length of the time period (in seconds) to count matched packets for a classifier rule.
Enter an integer from 0-65535. 0 means that no logging is done.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Loading ...
Loading ...
Loading ...