Loading ...
Loading ...
Loading ...
20
EN
3. Motor stops
while mowing.
A. Release Operating Bail to
turn mower off. Remove the
batteries, turn mower over
to check if mower is plugged
with grass debris, remove
debris from blade rotation
area. Then, check that
blade is free to turn. If not
free, return to an authorized
servicer. Blade should turn
freely.
B. Raise cutting height of
wheels to highest position
and start mower.
C. Has battery been fully
charged? Plug in charger
and wait for green light to
come on.
D. Avoid overloading the
mower. Slow down the
cutting pace by pushing
mower slower or raise the
cut height. Or both.
4. Mower runs
but cutting
performance is
unsatisfactory, or
does not cut entire
lawn.
A. Has battery been fully
charged? Plug in charger and
wait for green light to come on.”
B. Release Operating Bail to
turn mower off. Remove the
batteries. Turn mower over and
check: Blade for sharpness -
Keep blade sharp. Deck and
discharge chute for clogging.
C. Wheel height adjustment
may be set too low for grass
condition. Raise cutting height.
5. Mower is too
hard to push.
A. Raise cutting height to
reduce deck drag on grass.
Check each wheel for free
rotation.
6. Mower is
abnormally noisy
and vibrates.
A. Release Operating Bail
to turn mower off. Remove
the batteries. Turn mower
on side and check blade
to ensure it has not been
bent or damaged. If blade
is damaged, replace with
a replacement blade. If the
underside of the deck is
damaged return mower to an
Authorized service center.
B. If there is no visible
damage to the blade and the
mower still vibrates: Release
Operating Bail to turn mower
off, remove the batteries, and
remove blade. Rotate blade
180 degrees and retighten. If
mower still vibrates, return
the mower to an authorized
service center.
7. Battery charger
LED’s not on.
A. Check plug connection.
B. Replace charger.
8. Battery charger
LED does not ip to
green.
A. Battery needs to
be diagnosed. Take to
authorized service center.
9. Mower not
picking up clippings
with the Grass
Collection Bag.
A. Place Mulching / Side
Discharge -Bagging Switch
Lever into the bagging
position (chute no blocked
by plate).
B. Chute clogged. Release
Operating Bail to turn mower
off. Remove the batteries.
Clear chute of grass
clippings.
C. Too much cut grass. Raise
cutting height of wheels to
shorten length of the cut.
D. Bag full. Empty bag more
often.
10. When mulching
there are clippings
visible.
A. Too much cut grass. Raise
cutting height of wheels to
shorten length of the cut. Do
not cut off more than 1/3 of
total length.
B. Check blade for
sharpness. Always keep
blade sharp.
C. Reduce speed if grass is
high or extremely thick.
11. Low or
diminished run-time
after many uses
A. Return to Authorized
Service location - may need
new battery.
12. The battery
charger LED ashes
red and the battery
can’t be charged.
A. The battery overheats
after continuous use.
Remove battery from the
charger and allow it to cool
to 42°C or less.
13. If the Mulching-
Bag Lever will not
move.
A. Remove battery packs.
B. Place the mower in the
upright storage position.
C. Clean grass off of the
mulching plate.(See Fig. P)
D. After cleaning grass from
from mulch plate and mulch
plate groove, the edges of
the mulch plate and the
groove may be lubricated
with a household aerosol
lubricant such as WD-40 or
PAM.
Loading ...
Loading ...
Loading ...