Loading ...
Loading ...
Loading ...
INSTALLATION
02
NameNumber UsePicture Note
1
2
3
4
5
6
7
8
2x Left Wheel Installing
parts
2x Right Wheel
Installing parts
Roller is
installed on the left
side of the front of
the machine
Install for the rotating
shaft left front wheel
Accessories for
sealing film
installation:
2x spacers
2x clips
2 x spring
1x 90 aluminum ring
3x L -Wrench
1x Motor Sensor
Needle
Ix Silicone Plug
To hold sealing film
left and right
for clamping and
buffering of the left
wheel, no clamping
on the right
Fit with 3-1/2 inch or
3-2/3 inches sealing
cups
Please save the
important parts
For unscrewing the
aluminum plate screws
Use for debugging the
electronic eye to
avoid E51/E52 error
Block the heating plate
hole to avoid dirty
liquid flow on
the desktop.
If you have any further needs or question, please look into the Question & Answer
booklet. To solve all the information.
REMIND
07
PARAMETER
ERROR CODE TIPS
RESET SETTINGS SETUP PARAMETER
1. Press "Sound" for 3 sec to enter
the parameter adjustment mode.
2. Press "Sound" to exchange the
selection mode: P001-P006
3. Press " " and " " to adjust the
value.Press to ROLLING/CANCEL
to save the setting and return to
the working interface.
P001: Use for temperature adjustment, Range :0-230,
Default Value is 180
P002 Contain 2 mode: ON/OFF. ON: able to use for clear data;
OFF/CLEAR cannot be cleared (CLEAR key lock),
the default is OFF
P003: Sealing cups' time adjustment, Range: 0-50,
Default Paramater:15, Each Valve: represent 0.1sec
P004: Cup pushing in time range:0-30, default set:15
P005: Cup launching time range:0-60, default set:0
P006: Re-seal mode, repeat sealing twice . Default OFF,
choose when the weather is cold
E1-E4,E11-E14
E10
E51/E52
Machine wires error, Contact the After-Sales team
The temperature of the Heating Plate is over 350°C,
Turn off the machine & contact the after-sales team.
Motor Sensor Error. Use the Motor Sensor Needle to Adjust it.
ERROR CODE
SOLUTION
Loading ...
Loading ...