Loading ...
Loading ...
Loading ...
4
GETTING STARTED
m WARNING: Open protective hard cover during
ignition.
m WARNING: Do not lean over open grill while igniting
or cooking.
m WARNING: If ignition does not occur within five
seconds, turn the burner control knob to the o
position. Wait five minutes to allow accumulated
gas to dissipate, and then repeat the lighting
procedure.
m WARNING: Do not operate grill with the protective
hard cover closed. The protective hard cover is to
be used for storage purposes only to protect the
griddle.
Leveling the Grill and/or Griddle Cook Top
To ensure the proper and safe use of this grill, it is
important to make sure the grill is on a level, stable surface
before operating. In the event that your surface and/
or griddle cooktop is non-level you can adjust the feet to
correct. To adjust the feet, slightly lift one corner of the grill
and turn the feet right or left to raise or lower (E).
CAUTION: DO NOT ATTEMPT TO LEVEL THE GRILL DURING
OPERATION OR WHILE THE GRILL IS STILL HOT.
What is a Leak Check?
Once the LP tank is properly installed, it is necessary to
perform a leak check. A leak check is a reliable way to verify
that gas is not escaping after you connect the tank. The fuel
system in your grill features factory-made connections that
have been thoroughly checked for gas leaks and the burners
have been flame-tested.
WEBER recommends performing a thorough leak check
after assembly, as well as every time you disconnect and
reconnect a gas fitting. The following fittings should be
tested:
• Where the cylinder connects to the regulator.
• Where the regulator connects to the hose.
• Where the hose connects to the valve.
Checking for Gas Leaks
1) Make sure burner control knob is turned o by pushing it
in and turning it clockwise to the o ( ) position.
2) Wet fittings (A) with a soap and water solution, using a
spray bottle, brush, or rag. You can make your own soap
and water solution by mixing 20% liquid soap with 80%
water; or, you can purchase leak check solution in the
plumbing section of any hardware store.
3) If bubbles appear there is a leak:
a) If the leak is at the cylinder (B), remove the propane
cylinder. DONOT OPERATE THE GRILL. Install a
dierent propane cylinder and recheck for leaks with
a soap and water solution. If the leak persists, remove
the propane cylinder. DO NOT OPERATE THE GRILL.
Contact the Customer Service Representative in your
area using the contact information on our website.
b) If the leak is at the regulator (C) or burner valve (D),
turn o the gas. NEVER ATTEMPT TO TIGHTEN THE
REGULATOR. DO NOT OPERATE THE BARBECUE. Contact
the Customer Service Representative in your area using
the contact information on our website.
If a leak is present, contact the Customer Service
Representative in your area using the contact
information on our website.
4) If bubbles do not appear, leak checking is complete:
a) Rinse connections with water.
NOTE: Since some leak test solutions, including soap and water,
may be slightly corrosive, all connections should be rinsed with
water after checking for leaks.
m DANGER: Do not use a flame to check for gas leaks.
Besure there are no sparks or open flames in the
area while you check for leaks.
m DANGER: Leaking gas may cause a fire or explo-
sion.
m DANGER: Do not operate the grill if there is a gas
leak present.
m DANGER: If you see, smell, or hear the hiss of gas
escaping from the liquid propane tank:
1) Move away from liquid propane tank.
2) Do not attempt to correct the problem
yourself.
3) Call your fire department.
A
B
C
D
E
OFF START/HIGH MEDIUM LOW
Burner Control Knob Settings
Burner 1
Burner 2
22in Model Only:
Loading ...
Loading ...
Loading ...