Loading ...
Loading ...
Loading ...
19sharkclean.co.uk18 sharkclean.co.uk
MAINTAINING YOUR VACUUM
5. Tap o loose debris and wipe the brushroll
clean with a dry towel� Hand wash the
brushroll if needed, using only water,
and then let it air dry completely for at
least 24 hours�
6. When the brushroll is dry, reinstall it into
the nozzle by inserting it into the nozzle
until it clicks�
NOZZLE MAINTENANCE
POWERFIN FLOOR NOZZLE
1. Turn o the vacuum�
2. Press the nozzle release button to detach
the nozzle from the wand�
3. Press the brushroll release button and
slide the brushroll out of the nozzle�
4. Clear any blockages and remove any
debris from the brushroll and floor nozzle�
For best results, clean your Auto-Empty filters at least once a month and replace the filters regularly� To clean filters, rinse with cold water
ONLY to prevent damage from cleaning chemicals� Allow all filters to air-dry for at least 24 hours before reinstalling them to prevent
liquid from being drawn into electrical parts� Maintaining your Exhaust Foam Filter will ensure successful Auto-Empty evacuation�
CLEANING THE AUTO-EMPTY DOCK FILTER (IW3000 SERIES)
To access the filter in the dock, remove the Filter
Door� Press the button at the bottom of the door,
then tilt the door and lift it o� Remove the filter
from the dock� After the filter has been rinsed
and dried, reinstall it by reinserting it into the
dock and replacing the filter door�
MAINTAINING YOUR VACUUM
CLEANING THE SENSORS
Make sure to clean the Detect sensors
regularly, as hair and other debris may build
up and obstruct them� If the sensors are
partially obstructed, Clean Sense Detect
mode will not function as expected�
To clean the sensors:
1. Turn o power and remove the floor nozzle�
2. Locate the Dirt Detect Sensor in the nozzle
of the hand vac (Fig� 1), the Light Detect
Sensor on the top of the nozzle (Fig� 2),
and the Edge Detect sensor on the side of
the nozzle (Fig� 3)�
3. Gently wipe the sensors with a microfibre
cloth and remove all hair and debris�
4. Reattach the floor nozzle to the rest of the
unit and turn on power� Verify that the unit
is functioning normally�
DIRT DETECT SENSORS
Fig. 1
CLEANING THE LIGHT DETECT SENSOR
Fig. 2
Battery
Dust cup
Air path
CLEANING THE EDGE DETECT SENSOR
To access the the Auto-Empty Exhaust Foam
Filter, remove the dust bin� Before removing
the Exhaust Foam Filter, vacuum o any fine
debris from the surface� Lift the Exhaust
Foam Filter out of the dock, then rinse it with
water only (do not use soap)� Allow the filter
to air-dry completely before reinstalling it�
Loading ...
Loading ...
Loading ...