Loading ...
Loading ...
Loading ...
Rinnai Australia 7 Operation Manual
INSTALLATION
UNPACKING THE APPLIANCE
Check for damage. If the heater is damaged, DO NOT INSTALL and contact your supplier for advice.
WHAT’S IN THE BOX
The following items should also be included in the carton: This Operation Manual and Remote Control
with Battery.
BEFORE INSTALLING THE APPLIANCE
• Check it is labelled for the correct gas type (see label on rear of heater). Refer to
local gas authority for confirmation of gas type if you are in doubt
• The appliance must be installed in accordance with the local gas and electrical
authority regulations.
• A dedicated 240 V Earthed 10 Amp power point must be used with this appliance.
• For information on gas consumption, see data plate on the appliance.
• When using this appliance, ensure that the room is correctly ventilated, in
accordance with the section “VENTILATION” on page 8 and the warning label
located on the appliance. For further information regarding room ventilation contact
Rinnai or your local gas authority.
• DO NOT USE THIS APPLIANCE TO HEAT A BEDROOM, BATHROOM, TOILET,
COMBINED LIVING/SLEEPING AREA OR SAUNA.
• DO NOT CONNECT TO A PROPANE (LPG) GAS CYLINDER INDOORS.
• This appliance must not be
installed where curtains or other
combustible materials could come
into contact with it. In some cases
curtains may need restraining.
• This appliance is not designed to
be built in.
• This appliance must not be located
below a power socket-outlet.
• If you move house, check the gas
type in the area where you are
moving to.
• The local gas and electrical
authorities will be able to advise on
local regulations.
• Heat emanating from the front of this appliance may over time affect the appearance
of some materials used for flooring such as carpet, vinyl, cork or timber. This effect
may be amplified if the air in the room contains cooking vapours or cigarette smoke.
To avoid this possibility, it is recommended that a mat be placed in front of the
appliance, extending at least 750 mm in front of it.
• The appliance is not intended for use by young children or infirm persons without
supervision.
• Young children should be supervised to ensure they do not play with the appliance.
• If the supply cord or gas hose are damaged or require replacing, they must be
replaced by the manufacturer or the manufacturer's agent or similarly qualified
person in order to avoid a hazard.
• The Avenger / Blaze heaters wiegh 12.5 kg and the Dynamo / Enduro heaters weigh
10 kg. Exercise caution when lifting or moving an appliance.
IMPORTANT
50mm
750mm
50mm
50mm
50mm
The above diagram shows the clearances required
around this heater whilst in operation.
Loading ...
Loading ...
Loading ...