Loading ...
Loading ...
Loading ...
www.PyleUSA.com
Installation Transcript:
1. Locate the reverse taillight wiring behind your vehicle's reverse light. You may need to remove an interior
panel, or other cover, in order to locate the wiring. Connect a wireless module to the reverse light.
2. Connect the camera to the wireless module, then mount the camera in the desired location.
3. Mount the display monitor.
Camera Connection (Using the Wireless Transmitter):
a. Connect the wireless module's Red wire to your vehicle's reverse light positive wire.
b. Connect the wireless module's Black wire to your vehicle's reverse light negative wire.
c. Ensure the wires are safely and securely connected, with proper isolation applied to all connections.
d. Determine the best location to mount the wireless modules, as they are not waterproof and need a safe
and secure location.
Monitor Connection
a. Stick the monitor to window shield using the suction cup.
b. Use the cigarette plug to get power.
Notes:
• Determine the best location for the camera (Keep in mind that you must run the cable from the camera to
the transmitter). You may need to drill a small hole in the panel near your license plate (The camera is
preferably mounted just above the license plate).
• Be sure when running the connection cables to leave a small amount of slack so you can still move the
camera around the license plate, if you decide to slightly adjust the camera's positioning at a later time.
• Test the camera and monitor system once you have completed installation. Activate your car and turn the
key into the accessory position. Your connected monitor will automatically power on if properly
connected to a power source. Placing your vehicle in reverse should provide a picture.
3
Loading ...
Loading ...