Loading ...
Loading ...
System Installation and Wiring
Notes:
Camera System installation on diesel vehicles may require a slightly dierent wiring install.
These installation instructions do not apply to all types of vehicles. They are meant only as a general guide
due to the large number of vehicle makes and models. Consult your local motor vehicle laws on the use of
this product to be sure it is permitted.
Through installation of this backup camera system, you should be sure as to not degrade, damage or com-
promise the safety of any system or device on your vehicle.
Improper installation and wiring of the Vehicle Back-Up Camera system may damage the vehicle's electrical
system, including vital vehicle computer and operating systems. That could lead to an accident or re,
causing property damage and /or serious personal injury. It is highly recommended to seek professional
installation advice from a qualied auto electrician or, in the alternative, to have the installation performed
by a qualied auto electrician.
Please ensure that monitor is secured and mounted where it would NOT obstruct any OEM vehicle safety
features. In an event of an accident, manufacturer is not responsible for bodily injury caused by the monitor
being a projectile. Select location for mounting the monitor in desired location. Ensure monitor location will
not obstruct your vision while driving.
The manufacturer assumes no liability for damage caused to your vehicle due to improper installation or use.
Caution: This unit is designed to operate on a 12V/24V DC NEGATIVE GROUND electrical system. Connecting
to other types of electrical systems will cause damage to your vehicle. Please contact the manufacturer if you
are unaware of the system type in your vehicle.
Quick Installation:
The 2.4 G wireless modules come in two parts, they are used as the "Transmitter” and the "Receiver". When
installing, the “Transmitter”, should be connected to the camera (the camera is preferably mounted in the rear
of the vehicle, just above the license plate). The receiver is built in the display monitor. This receives the signal
from the camera connected to the transmitter.
Connect the transmitter's red power wire, of the DC 12V input cable, to the positive 12V reverse tail light in
the rear of your car. Then connect the black wire, of the DC 12V input cable, and ground properly.
The transmitter then connects to the camera, and will supply power to the camera directly.
2
www.PyleUSA.com
Loading ...
Loading ...
Loading ...