Loading ...
Loading ...
Loading ...
Burner will
not light
with match
The fire pit
emits a lot
when in
use
Obstruction of
gas flow
Spider webs or
insect nest in
the venturi
Clean the venturi.
Burner ports
clogged or
Reference Problem: Irregular
flame pattern on the following
page. Clean the burner ports as
described there.
Hose from gas
fire pit is
pinched
pinched between the fire pit
and the source of the gas.
Flame is being
obstructed at
burner ports or
mixing chamber
of the burn
or obstructed
on the burner are free of any
flame can flow naturally. Clear
out the mixing chamber located
before the Venturi.
Sudden drop
in gas flow,
or a reduced
flame height
Out of Gas
Excess flow
safety device
may have been
activated
seconds and light outdoor fire
pit.If flames are still too low,
reset the excessive flow safety
device by turning off the control
Disconnect regulator. Turn
Reconnect regulator and perform
outdoor fire pit.
Assembly InstructionsTrouble Shooting
Irregular
flame
pattern,
flame does
not run the
full length of
the burner
Flame blows
out
High or gusting
winds
Low on LP gas
Excess flow
valve tripped
Increase flame to HIGH setting.
Refer to Problem: Sudden drop
in gas flow.
Burner ports
are clogged or
Clean burner ports.Do this by
inserting a paperclip into each
of the burner ports to ensure
they are not clogged.
not on, and has had sufficient
time to cool before touching it.
Flame seems
to lose heat
when burning
in cold
weather -
temperature
Ice has built up
on the outside
of the LP gas
process is too
low
Replace with a spare LP gas
burning. Store the spare LP gas
ventilated area, away from
children.
Assembly InstructionsTrouble Shooting
Problem: Problem: The burner only lights up for a few
seconds, then it automatically turns off.
18 19
Loading ...
Loading ...
Loading ...