Loading ...
Loading ...
Loading ...
www.fhiaba.com · www.thevettagroup.com · Info Line 1-855-4-FHIABA (1-855-434-4222)
26
5.1 Overlay door-panel layout
The dimensions of the panels are indicated in the
table and drawings on the following pages.
However, depending on the requirements for
aligning with other kitchen structures, the door
panel can be higher than the upper edge of the
refrigerator door.
The panels must be mounted using special
brackets which attach to adjustable devices
provided on the door and drawer and with
brackets that anchor and adjust the panel’s
vertical orientation.
Brackets and fixing screws are provided with the
appliance and must be applied to the panel as
indicated.
For shaker or framed panel styles, it
may not be possible to affix the upper
or lower leveling brackets, unless the
cabinetmaker has made provisions for
mounting them with additional material
on the back of the panel.
Proceed as follows:
To prepare the panels for mounting on the applian-
ce, follow these steps on the back of the panel.
Door Panel
> Draw a vertical centerline on the panel from top
to bottom [ 1 ].
> Starting from the bottom edge of the panel,
mark the positioning of the brackets [ 2 ].
5. PANEL MOUNTING
2
1
> Following the corresponding table, first mark
the external hole and then the internal hole [ 3 ].
> Position the brackets on each set of marks to
make sure they are aligned [ 4 ]; if you choose to
drill small pilot holes for the screws, be especial-
ly careful not to pass through the panel entirely.
[ 5 ].
> Screw the brackets in place [ 6 ].
6
4
3
5
Loading ...
Loading ...
Loading ...