Loading ...
Loading ...
Loading ...
Installation Instructions
The appliance must not be located immediately below a socket outlet.
NOTE: Your Panel Heater should be installed with at least 150mm clearance from the
floor and any other surrounding parts including other appliances and side walls.
At least 300mm clearance from ceilings, shelves and soft furnishings.
Note: Do not run the power cord behind the heater.
WALL MOUNTED HEATERS ARE
ONLY TO BE MOUNTED ON HEAT
RESISTANT WALLS THAT COMPLY
WITH CURRENT AS/NZS
SPECIFICATIONS & BUILDING
REGULATIONS
150mm
300mm
150mm
150mm
WALL MOUNTED
1. Make sure the appliance is unplugged and power switches are off.
2. Position the panel appliance within one metre of a wall socket. Do not mount in
front of or below the wall socket. Ensure there is at least 150mm clearance on all
sides of the appliance.
3. Detach the mounting bracket from the back of the panel appliance by pressing
down on the locking tabs on the top of the mounting bracket and then put out
from back of heater.
4. Position the mounting bracket on the wall and mark the hole positions with a pen
or pencil and check they are horizontal with a spirit level. Ensure the two bottom
mount holes are at least 150mm from the floor and drill holes as required.
5. Secure the mounting bracket to the wall with the mounting screws. (For masonry
walls use the plastic sheaths).
6. Slot the back of the appliance onto the mounting bracket locating the bottom
plugs first and secure with two locking tabs.
7. Plug appliance into a standard 240 volt AC electrical outlet.
Loading ...
Loading ...
Loading ...