Loading ...
Loading ...
Loading ...
IMPORTANT SAFETY INFORMATION
Page 5
BEFORE INSTALLATION
We recommend this appliance be installed or
repaired by a qualied Schweigen Home
Appliances technician.
Please see our website www.schweigen.com.au
for a list of our recommended installers.
It is dangerous to modify any part of this appliance.
Modication of any kind will immediately void the
warranty.
The manufacturer declines all responsibility in case
of failure to adopt proper safety measures.
Ensure that the location in which this appliance is
installed, has good and permanent ventilation.
Please consult local laws and regulations and install
in accordance.
Please use an earthed electrical connector that
coincides with relevant local laws and regulations.
Check that the power voltage in your area
corresponds to the appliance voltage indicated on
the rating label.
This appliance must be connected to an electrical
supply that has a grounded connection.
Check that the indicated instructions and local
regulations are met and carried out by a qualied
technician, using materials that are complaint with
the applicable legislation.
Schweigen will not be responsible for any
installations executed by non-qualied technicians
that fail to heed the applicable legislation on
electrical safety.
The electrical technical data can be found inside
the rangehood, after removing the grease lters.
The exible power cables supplied are already
connected internally and emerges from the
rangehood near the air outlet tube.
Before installing the electrical connections,
you should:
• Verify that the indicated electrical data coincides
with the voltage values and frequency of
the electrical circuit in the house where the
rangehood is to be installed.
• Check that the premises has electrical protection
against short circuits and electrocution.
• Before commencing maintenance the current
must be turned o using the double-pole switch
(mains power switch). The power can only be
turned on for normal use, once the operation has
been completed.
• Ensure the supply cord is not exposed to
heat, chemicals or sharp objects. If the supply
cord is damaged, it must be replaced by the
manufacturer, service agent or a similarly
qualied person in order to avoid a hazard.
Loading ...
Loading ...
Loading ...