Loading ...
Loading ...
- Do not open the appliance to
replace the rechargeable
battery.
Caution
- Never immerse the charging
stand in water and do not
rinse it under the tap (Fig. 2).
- Never immerse the appliance
in water. Do not use the
appliance in the bath or
shower.
- Never use water hotter than
60°C to rinse the appliance.
- Only use this appliance for its
intended purpose as shown
in the user manual.
- For hygienic reasons, the
appliance should only be
used by one person.
- Do not use the supply unit in
or near wall sockets that
contain an electric air
freshener to prevent
irreparable damage to the
supply unit.
- Never use compressed air,
scouring pads, abrasive
cleaning agents or aggressive
liquids such as petrol or
acetone to clean the
appliance.
Electromagnetic fields (EMF)
This Philips appliance complies with all applicable
standards and regulations regarding exposure to
electromagnetic fields.
General
- This appliance can be safely cleaned under the
tap (Fig. 3).
- The supply unit is suitable for mains voltages
ranging from 100 to 240 volts.
- The supply unit transforms 100-240 volts to a
safe low voltage of less than 24 volts.
- Maximum noise level: Lc = 69dB(A)
Introduction
Congratulations on your purchase and welcome to
Philips! To fully benefit from the support that
Philips offers, register your product at
www.philips.com/welcome.
Charging
Battery status indicator
- When the battery is almost empty, the battery
charge indicator flashes orange.
- When the appliance is charging, the battery
charge indicator flashes white.
- When the appliance is fully charged, the battery
charge indicator lights up white continuously.
Note: After approx. 30 minutes, the light goes out
automatically.
It takes approximately 1 hour to fully charge the
appliance. When it is fully charged, the appliance
has a cordless operating time of up to 90 minutes.
1 Make sure the appliance is switched off.
2 Insert the small plug into the appliance and put
the supply unit in the wall socket (Fig. 6).
3 After charging, remove the supply unit from the
wall socket and pull the small plug out of the
appliance.
Using the appliance
- Note: This appliance can be used without cord
or when it is connected to the wall socket (Fig.
7).
Switching the appliance on and off
- Press the on/off button once to switch the
appliance on or off (Fig. 8).
Beard trimming
Trimming with comb
Note: When you trim for the first time, start at a
length setting that is longer than what you are
used to, to familiarize yourself with the
appliance.
- The appliance comes with two combs: a long
beard comb and a short beard comb.
- Use the trimming comb attached to the cutting
element to trim your beard and moustache in
your preferred style. Turn the zoom wheel to
choose from 20 length settings ranging from
10.4mm to 20mm (Fig. 10) (for the long beard
comb) and 0.4mm to 10mm (Fig. 11) (for the
short beard comb). The length settings are
mentioned at the back of the combs.
1 Make sure the appliance is switched off.
2 Slide the comb into the guiding grooves on
both sides of the appliance ('click’) (Fig. 9).
3 Turn the zoom wheel to select the desired
length setting (Fig. 10). The selected length
setting is shown on the front of the appliance.
The blue color refers to length settings ranging
from 10.4mm to 20mm (Fig. 14) and the silver
refers to length settings ranging from 0.4 to
10mm (Fig. 13).
Loading ...
Loading ...