Loading ...
Loading ...
Loading ...
- 8 -
To the speaker wires
of your head unit
R+
R-
L+
L-
White
Gray
Gray/Black
White/Black
• Using the supplied high-level input wire harness, connect the HIGH INPUT connector to speaker output
wires of your head unit. Make sure to observe speaker polarity.
• Make sure the speaker wires are securely connected and properly insulated. Run the wires under the
vehicle mats for wire protection.
Power Connection
Important! The power wire must be connected to the battery through a correct fuse (not included).
To the remote output
wire of your head unit
Metal frame
of the vehicle
1
2
Fuse
(not included)
12V
Battery
3
1. Using an 8 gauge (or heavier) wire, connect the GND terminal on the subwoofer to the metal frame of your
vehicle. Keep the ground wire less than 39” (100 cm) in length.
Scrape away any paint, rust or dirt from the ground point to provide a clean contact. Fasten the ground wire
on the ground point with a screw or bolt.
2. Using a 16 gauge (or heavier) wire, connect the REM terminal on the subwoofer to the remote output wire
of your head unit.
If high-level input connection is made, you do not need to make the REM terminal connection. With high-
level input connection and auto power on feature activated (prssing the AUTO POWER ON switch on the
subwoofer), the subwoofer can be turned on or off automatically whenever the connected head unit is
turned on or off.
Loading ...
Loading ...
Loading ...