Loading ...
Loading ...
Loading ...
- 6 -
Protection Mode
When protection mode triggers, the red LED on the subwoofer turns on and the subwoofer shuts down.
One of the following reasons can trigger protection mode: input overload, short circuit and extremely high
temperature.
When the red LED turns on, take the following measures.
• Check the audio system carefully to determine what has caused the protection mode to trigger.
• Reset the subwoofer. Turn off the subwoofer (by turning off the head unit or other audio source which feeds
the subwoofer) and turn it on again.
• If the shutdown was due to either an input overload or a short circuit, correct the conditions which cause the
overload or short circuit then turn on the subwoofer again.
Mounting
See the section “Installation Precautions” on page 3.
Before you drill or cut any holes, investigate your car’s layout very carefully. Take special care when
you work near the fuel tank, fuel lines, hydraulic lines and electrical wiring.
Make sure there is sufcient air circulation around the intended mounting location.
Mount the subwoofer in the location away from moisture, and where connection cables are not
pinched or damaged by sharp objects.
1. Find a suitable location in the vehicle to mount the subwoofer. A typical location is under the front or rear
seat of the vehicle, as shown below.
2. Secure the subwoofer with four supplied screws and rubber washers as follows:
a. Use the four screw holes on the subwoofer to
mark the mounting holes on the mounting surface.
b. Drill the mounting holes on the mounting
surface.
c. Place the subwoofer in position, and attach
the subwoofer to the mounting surface using four
screws and rubber washers.
Remeber to attach the rubber washers for secure
fastening.
Rubber washer
Loading ...
Loading ...
Loading ...