Swisher ZTR2466BS-CA Response Gen 2 - 24 HP/66" B&S Zero Turn Riding Mower

User Manual - Page 9

For ZTR2466BS-CA.

PDF File Manual, 24 pages, Read Online | Download pdf file

ZTR2466BS-CA photo
Loading ...
Loading ...
Loading ...
һ
Operator Presence System:
Be
sure to check that the operator presence and interlock systems are working properly before each use. If your
mower does not function as described, repair the problem immediately.
The engine should not start unless the parking brake is engaged and the PTO (Blade Engagement Switch)
is disengaged (pressed down).
See OPERATION FEATURES section of this manual.
When the engine is running and the brake is disengaged, the operator should never leave the seat without first
setting the parking brake and shutting off the engine. If the operator attempts to leave the seat without first setting
the brake, the engine should shut off.
When the engine is running and the PTO switch is engaged, any attempt by the operator to leave the seat without
first disengaging the PTO switch, should shut off the engine.
The PTO switch should never engage without the operator on the seat.
Tires:
Maintain proper air pressure in all tires (SEE SPECIFICATIONS section).
Ke
ep tires free of gasoline, oil or insect control chemicals which can harm rubber.
Avoid stumps, stones, deep ruts, sharp objects and other hazards that may cause tire damage.
Blade Maintenance:
For best results, mower blades must be kept sharp.
Replace bent or damage blades.
Engage brakes & safely raise front of mower (SEE WARNING).
Hold or block blade from turning.
Loosen blade nut and remove blade.
Replace blade (SEE SPECIFICATIONS).
Battery:
To
clean battery and terminals
Remove the BLACK terminal guard.
Disconnect the BLACK battery cable and locate it where it
cannot come into contact with the battery.
Remove the RED terminal guard.
Disconnect the RED battery cable and locate it where it
cannot come into contact with the battery.
Remove the battery.
Rinse the battery with plain water and dry.
Clean terminals and battery cable ends with wire brush
until shiny.
Coat terminals with Dielectric Grease or Petroleum Jelly.
(This helps seal and prevent corrosion.)
Reinstall battery.
Reconnect the battery cables. Attach the RED cable first
then the BLACK cable.
WARNING
W
hen it is necessary to raise the mower
for any repair or service, use jackstands
to provide adequate support. DO NOT
rely on hydraulic or mechanical jacks.
CAUTION
St
op engine, apply brakes, and remove
ignition key for safety. Disconnect spark
plug wire. Wear heavy, thick gloves when
holding onto blade. Avoid the sharp edge
of the blade.
CUSTOMER RESPONSIBILITIES
9
WARNING
T
he battery contains sulfuric acid and
electrolytes which are poisonous and
corrosive.
Loading ...
Loading ...
Loading ...