Loading ...
Loading ...
3
Install exterior assembly
A
Before installation, make sure the latch is fully retracted (in the unlocked position).
B
Route the cable below the latch.
2 / 6
4
Install interior assembly
B
Rotate the thumbturn in upward position and
make sure the latch is still fully retracted.
Insert the torque blade through center hole
mounting plate.
C
5
Detect left/ right hand door installation
While the door is OPENED and UNLOCKED,
load 3 AA batteries into the battery compartment.
For best results, use new, non-rechargeable
Alkaline batteries only. Do not mix old and new
batteries.
Perform a factory reset to teach the lock the orientation of the door.
Always run this step after installation. The motor will not operate before completing the step.
A
Press and hold the Reset button using a
pen or a paper clip.
Do not release the reset button until you
completed the next step.
B
Place the 4th battery and keep holding the reset button,
until the latch bolt extend.
If the latch doesn’t extend within 10 seconds, repeat step
4C and 5A, making sure the thumbturn is always facing
upwards and latch always in unlocked position.
C
Send the cable through the bottom horizontal slot
in the mounting plate.
C
Test the thumbturn for smooth rotation.
If thumbturn doesn’t rotate, repeat step 4B,
making sure the thumbturn facing upwards.
D
horizontal
D
Secure the mounting plate with the supplied screws.
E
J
Keep Parallel to door edge
Secure the interior
assembly with screw K.
E
K
unlocked
unlocked
Do not load batteries until lock
is completely installed.
Remove the battery cover.
A
G
F
unlocked
Connect the cable and ensure
tight cable connection.
unlocked
thumbturn
facing
upwards
Loading ...
Loading ...
Loading ...