Loading ...
Loading ...
Loading ...
Part 1 – Introduction
9
I/O Device Port
6
1
2
3
4
5
7
1
Network Port
2
FGND (Frame Ground)
3
Power Connector
4
Audio Out
5
Audio In
6
Alarm In
7
Alarm out
• Network Port
Connect a network cable with an RJ-45 connector to
this port. If using a PoE switch, you can supply power
to the camera using an ethernet cable. For more
information on PoE switch use, refer to the switch
manufacturer's operation manual. You can congure,
manage, and upgrade this camera and monitor its
images from a remote computer over the network.
For more information on network connection setup,
refer to the IDIS Discovery operation manual.
• FGND (Frame Ground)
Used to ground the device.
• Power (DC12V)
Connect this to the power adapter. An A-type jack
is used for the power adapter. (External diameter x
internal diameter: 5.5 mm x 2.5 mm(0.22" x 0.10"))
The following table describes the network cable
specications.
<The network cable specications>
Item Content Note
Connector RJ-45
Ethernet 10/100 Base 10/100 Mbps
Cable
UTP Category 5 or
higher
Maximum
length
100m
PoE IEEE 802.3af, Class 3
• Audio Out
Connect an amplier to this port (line out). This device
does not feature a built-in audio amplier unit and
therefore requires the user to purchase a separate
speaker system with a built-in amplier.
• Audio In
Connect an audio source to this port (line in). A built-
in microphone is featured on the front.
• Alarm In / Out
- In: Connect an alarm-in device to this port.
(Mechanism: Choose between an NC (Normally
Closed) type or an NO (Normally Open) type) →
Connect a mechanical or electrical switch to the
alarm in port and the GND (ground) connector.
Alarm in range is 0V to 5V. In order to detect alarm
input from an electrical switch, the signal must be
higher than 4.3V from an NC switch or less than
0.3V from an NO switch and must last for longer
than 0.5 seconds.
Loading ...
Loading ...
Loading ...