Loading ...
Loading ...
Loading ...
Part 1 – Introduction
8
Overview
Product color and design may vary depending on the
model.
Top Cover
• Built-In IR LED
A sensor in the middle monitors lighting levels and
activates the IR LED during low-lighting conditions.
Body
1
2
6
4
5
3
1
Lens
2
Wall/Ceiling Installation Hole
3
Sensor
4
Factory Reset Button
5
SD Memory Card Slot
6
Built-in Microphone
• Lens
A lens is mounted.
Before you install this product, remove the peel o
lm attached to the surface of the lens.
• Wall/Ceiling Installation Hole
Used to screw the camera in place on a wall or a
ceiling.
• Sensor
There is a sensor for monitoring lighting levels.
• Factory Reset Button
Restores the camera's default factory settings. For
more information, refer to the Factory Reset on page
10.
• SD Memory Card Slot
Used to insert a microSD memory card into the
camera. (An SLC (Single Level Cell) or MLC (Multi Level
Cell) card by SanDisk or Transcend is recommended)
For more information, refer to the Inserting a SD
Memory Card on page 11.
• Do not remove the SD memory card while the
system is in operation. Removing the card while
the system is in operation can cause the system
to malfunction and/or corrupt data stored on the
SD memory card.
• An SD memory card is a consumable product
with a nite service life. Prolonged use will
damage the card's memory sectors and result
in data loss or memory card failure. Test the SD
memory card regularly and replace it whenever
necessary.
• Built-in Microphone
Receives audio.
Loading ...
Loading ...
Loading ...