Loading ...
Loading ...
Loading ...
Preparing for use
R&S
®
RTB2000
23Getting Started 1333.1605.02 ─ 08
1. Plug the AC power cable into the AC power connector on the rear panel of the
product. Only use the AC power cable delivered with the product.
2. Plug the AC power cable into a power outlet with ground contact.
The required ratings are listed next to the AC power connector and in the data
sheet.
3.7 Switching on or off
The instrument is switched on or off with the power switch and the [Standby] key.
Table 3-1: Overview of power states
Status LED Power switch
Off
(unlighted)
[0] (off)
Standby
yellow
[I] (on)
Ready
green
[I] (on)
To switch on the product
The product is off but connected to power.
1. Set the switch on the power supply at the rear panel of the instrument to posi-
tion [I].
The power key lights up. The key is located in the bottom left corner of the
front panel.
2. Press the [Standby] key.
The instrument performs a system check and then starts the firmware.
The [Standby] key turns green and the illuminated keys on the front panel light
up. If the previous session was terminated regularly, the oscilloscope uses the
last settings.
Before you start measurements, be sure to comply with the warm-up phase
specified in the data sheet.
To shut down the product
The product is in the ready state.
► Press the [Standby] key.
Switching on or off
Loading ...
Loading ...
Loading ...