Loading ...
Loading ...
Loading ...
14.2. Connecting line voltage
Make sure power supply is off.
The unit should be installed by a licensed contractor/electrician. If required by applicable national,
state, and local codes, a disconnect switch will need to be installed when the indoor unit is powered
from the outdoor unit.
All wiring must conform to National and Local codes
“No ilter sign indicator”
Humidiier control
Remark:
* Use a ring tongue terminal in
order to connect a ground wire
to terminal.
Grounding Terminal*
Grounding Terminal*
Grounding
terminal*
Disconnect
switch
NOTE
If the air handler will be installed with electric heat package do not power the electric heat
from the outdoor unit.
All wiring must conform to national and local codes
1. Remove the desired knockout on the air handler.
2. Attach a conduit pipe connector to the air handler and route the wiring as shown in the above diagram.
Ensure conduit connection hole is air tight and add a sealant if necessary.
3. Firmly tighten all of the terminal screws. After tightening, verify that the wires are tightly fastened.
SVZ-KP12,18, 24, 30, 36NA
© 2022 Mitsubishi Electric US, Inc. 44 Specifications are subject to change without notice.
ENGLISH
Loading ...
Loading ...
Loading ...