Loading ...
Loading ...
Loading ...
4
Installing the Dust Cover
The dust cover is used with the vacuum attachment
to help seal the dust around the front of the tool for
more ecient dust collection.
1. WARNING! Remove battery to avoid starting the tool.
2. Slide the cover onto the tool in the orientation
shown until it clips in place.
3. To remove, squeeze and pull away from the tool.
NOTE: Do not use the dust cover when making
bevel/angle cuts.
Using the Anti-Splinter Plate
The anti-splinter plate helps
Anti-splinter
Shoe
stabilize the workpiece and re-
duce workpiece splinter.
1. WARNING! Remove battery
to avoid starting the tool.
2. Slide the anti-splinter plate
onto the shoe. Make sure the
anti-splinter plate is installed
ush with the bottom of the
shoe.
NOTE: Do not use the anti-splinter plate when mak-
ing bevel/angle cuts.
Using the Shoe Cover
The shoe cover is used to prevent marring and
scratching of the workpiece surface.
To attach the shoe cover:
1. WARNING! Remove battery to avoid starting the tool.
2. Hook the front of the cover over the metal shoe.
3. Snap the rear of the shoe cover over the back of
the shoe. Be sure both sides are snapped in place.
4. When the shoe cover is not needed, remove it by
pulling the tabs on rear of the shoe cover down.
Unhook the front of the shoe cover and remove.
5. Two saw blades can be stored inside the shoe
cover.
SYMBOLOGY
Volts
Direct Current
No Load Strokes per Minute (SPM)
UL Listing for Canada and U.S.
ASSEMBLY
WARNING
Recharge only with the charger
specied for the battery. For spe-
cic charging instructions, read the operator’s
manual supplied with your charger and battery.
Removing/Inserting the Battery
To remove the battery, push in the release buttons
and pull the battery pack away from the tool.
WARNING
Always remove the battery pack
any time the tool is not in use.
To insert the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
WARNING
Only use accessories specically
recommended for this tool. Others
may be hazardous.
Installing Saw Blades
Use only T-Shank jig saw blades.
1. WARNING! Remove battery to avoid starting the tool.
2. Firmly rotate the blade change lever as far as it
will go and hold it in position.
3. Fit the saw blade into the groove in the support
roller and push it rmly into the plunger as far as
it will go; the lug of the saw blade must be in the
plunger.
Plunger
Slot
Lug
Blade
4. Release the blade change lever and the saw blade
is automatically held.
5. Check that the saw blade is held rmly; the slot in
the plunger will be at an angle to the blade.
Loading ...
Loading ...
Loading ...