Loading ...
Loading ...
Loading ...
Part 1 – Introduction
9
Cable
1
2
3
1
Network Port
2
Audio In/Out
3
Alarm In/Out
• Network Port
Connect a network cable with an RJ-45 connector to
this port. If using a PoE switch, you can supply power
to the camera using an ethernet cable. For more
information on PoE switch use, refer to the switch
manufacturer's operation manual. You can congure,
manage, and upgrade this camera and monitor its
images from a remote computer over the network.
For more information on network connection setup,
refer to the IDIS Discovery operation manual.
• Audio In
DC-E4216WRX model only
Connect an audio source to this port. (line in)
• Audio Out
DC-E4216WRX model only
Connect an amplier to this port (line out). This device
does not feature a built-in audio amplier unit and
therefore requires the user to purchase a separate
speaker system with a built-in amplier.
• Alarm in
Connect an alarm-in device to this port. Connect a
mechanical or electrical switch to the IN and GND
(ground) connectors. Alarm in range is 0V to 5V. In
order to detect alarm input from an electrical switch,
the signal must be higher than 4.3V from an NC
switch or less than 0.3V from an NO switch and must
last for longer than 0.5 seconds.
• Alarm Out
It is the BJT (Bipolar Junction Transistor) - open
collector output. If the voltage and current exceed
the specication limit (max. load: 30mA, max.
voltage: 5VDC), the product could be damaged.
When connecting the device which exceeds the
specication limit, refer to the picture (circuit) below.
If used with an external inductive load(e.g. relay), a
diode must be connected in parallerl with the load
for protection. Otherwise, the product could be
damaged.
• Check your local laws and regulations on making
video or audio recordings. The user will be held
liable for any violation of the law.
• The network connector is not designed to be
connected directly with cable or wire intended
for outdoor use.
Loading ...
Loading ...
Loading ...