Loading ...
Loading ...
3
SECTION 1 — IMPORTANT SAFE OPERATION PRACTICES
Slope Operation
Slopes are a major factor related to
slip and fall accidents, which can result
in severe injury. Operation on slopes
requires extra caution. The machine is
heavy and can speed up when going
downhill. Be prepared to maintain control
of the machine. If you feel uneasy on a
slope, do not mow it. For your safety,
use the slope gauge included as part of
this manual to measure slopes before
operating this machine on a sloped or
hilly area. If the slope is greater than 15
degrees, do not mow it.
Do:
1. Mow across the face of slopes; never up
and down to avoid loss of control.
2. Exercise extreme caution when
changing direction on slopes; turn uphill
not down.
3. Watch for holes, ruts, rocks, hidden
objects, or bumps which can cause
you to slip or trip. Tall grass can hide
obstacles.
4. Always be sure of your footing. A slip
and fall can cause serious personal
injury. If you feel you are losing your
balance, release the blade control
handle immediately and the blade will
stop rotating within three (3) seconds.
Do Not:
1. Do not mow near drop-offs, ditches
or embankments, you could lose your
footing or balance.
2. Do not mow slopes greater than 15
degrees as shown on the slope gauge.
3. Do not mow on wet grass. Unstable
footing could cause slipping.
Children
Tragic accidents can occur if the operator
is not alert to the presence of children.
Children are often attracted to the mower
and the mowing activity. They do not
understand the dangers. Never assume
that children will remain where you last
saw them.
1. Keep children out of the mowing area
and under watchful care of a responsible
adult other than the operator.
2. Be alert and turn mower off if a child
enters the area.
3. Before and while moving backwards,
look behind and down for small children.
4. Use extreme care when approaching
blind corners, doorways, shrubs, trees,
or other objects that may obscure your
vision of a child who may run into the
mower.
5. Keep children away from hot or running
engines. They can suffer burns from a
hot muffler.
6. Never allow children under 14 years of
age to operate this machine. Children 14
and over should read and understand
the instructions and safe operation
practices in this manual and on the
machine and be trained and supervised
by an adult.
7. After stopping engine, remove Electric
Start Push Key (if equipped) and keep
it in a safe place out of the reach of
children.
Service
Safe Handling Of Gasoline:
1. To avoid personal injury or property
damage use extreme care in handling
gasoline. Gasoline is extremely
flammable and the vapors are explosive.
Serious personal injury can occur when
gasoline is spilled on yourself or your
clothes, which can ignite. Wash your skin
and change clothes immediately.
2. Use only an approved gasoline
container.
3. Never fill containers inside a vehicle or
on a truck or trailer bed with a plastic
liner. Always place containers on the
ground away from your vehicle before
filling.
4. Remove gas-powered equipment from
the truck or trailer and refuel it on the
ground. If this is not possible, then
refuel such equipment on a trailer with
a portable container, rather than from a
gasoline dispenser nozzle.
5. Keep the nozzle in contact with the rim
of the fuel tank or container opening at
all times until fueling is complete. Do not
use a nozzle lock-open device.
6. Extinguish all cigarettes, cigars, pipes
and other sources
of ignition.
7. Never fuel machine indoors because
flammable vapors will accumulate in
the area.
8. Never remove gas cap or add fuel while
engine is hot or running. Allow engine
to cool at least two minutes before
refueling.
9. Never over fill fuel tank. Fill tank to no
more than 1 inch below bottom of filler
neck to provide for fuel expansion.
10. Replace gasoline cap and tighten
securely.
11. If gasoline is spilled, wipe it off the
engine and equipment. Move machine
to another area. Wait 5 minutes before
starting engine.
12. Never store the machine or fuel
container near an open flame, spark or
pilot light as on a water heater, space
heater, furnace, clothes dryer or other
gas appliances.
13. To reduce fire hazard, keep machine free
of grass, leaves, or other debris build-up.
Clean up oil or fuel spillage and remove
any fuel soaked debris.
14. Allow machine to cool at least 5 minutes
before storing.
General Service:
1. Never run an engine indoors or in a
poorly ventilated area. Engine exhaust
contains carbon monoxide, an odorless
and deadly gas.
2. Before cleaning, repairing, or inspecting,
make certain the blade and all moving
parts have stopped. Disconnect the
spark plug wire and ground against the
engine and remove Electric Start Push
Key (if equipped) to prevent unintended
starting.
3. Check the blade and engine mounting
bolts at frequent intervals for proper
tightness. Also, visually inspect blade
for damage (e.g., bent, cracked,
worn) Replace blade with the original
equipment manufacture’s (O.E.M.)
blade only, listed in this manual. “Use
of parts which do not meet the original
equipment specifications may lead to
improper performance and compromise
safety!”
4. Mower blades are sharp and can cut.
Wrap the blade or wear gloves, and use
extra caution when servicing them.
5. Keep all nuts, bolts, and screws tight to
be sure the equipment is in safe working
condition.
6. Never tamper with safety devices. Check
their proper operation regularly.
7. After striking a foreign object, stop
the engine, disconnect the spark plug
wire and ground against the engine.
Thoroughly inspect the mower for any
damage. Repair the damage before
starting and operating the mower.
8. Never attempt to make a wheel or
cutting height adjustment while the
engine is running.
9. Grass catcher components, discharge
cover, and trail shield are subject to
wear and damage which could expose
moving parts or allow objects to be
thrown. For safety protection, frequently
check components and replace
immediately with original equipment
manufacturer’s (O.E.M.) parts only, listed
in this manual. “Use of parts which
do not meet the original equipment
specifications may lead to improper
performance and compromise safety!”
10. Do not change the engine’s governor
setting or over-speed the engine. The
governor controls the maximum safe
operating speed of the engine.
11. Check fuel line, tank, cap, and fittings
frequently for cracks or leaks. Replace if
necessary.
12. Do not crank engine with spark plug
removed.
13. Maintain or replace safety and
instruction labels, as necessary.
14. Observe proper disposal laws and
regulations. Improper disposal of
fluids and materials can harm the
environment.
Loading ...
Loading ...
Loading ...