Loading ...
Loading ...
Loading ...
2N TELEKOMUNIKACE a.s., www.2n.cz 73/117
VLAN Enabled – enable the virtual network support (VLAN according to 802.1q).
Remember to set the VLAN ID too.
VLAN ID – choose a VLAN ID from the range of 1–4094. The device shall only
receive packets with the set ID. An incorrect setting may result in a connection
loss and subsequent factory reset.
Required Port Mode – set the LAN port mode to be preferred: Automatic or Half
Duplex – 10 Mbps. The bit rate is reduced to 10 Mbps in case the available LAN
cabling is unreliable for a 100 Mbps traffic.
Current Port State – current LAN port state: Half or Full Duplex – 10 Mbps or 100
Mbps.
Verify the network address accessibility – verify the network address
accessibility via the Ping command in standard operating systems. Press Ping to
display a dialogue for you to enter the IP address/domain name and press Ping
to send the test data to the set address. If the IP address/domain name is
invalid, a warning is displayed and the Ping button remains inactive until the IP
address becomes valid. The dialogue also displays the procedure state and
result. Failed means that either the IP address was unavailable within 10 s or it
was impossible to translate the domain name into an address. If a valid response
is received, the response sending IP address and response waiting time in
milliseconds are displayed. Press Ping again to send another query to the same
address.
801.1x
Device Identity – username (identity) for authentication via EAP-MD5 and EAP-
TLS.
Loading ...
Loading ...
Loading ...