Thor Kitchen TRE3001 30 Inch Freestanding Professional Electric Range with 5 Elements, 4.55 cu. ft.

Use and Care Manual - Page 38

For TRE3001.

PDF File Manual, 50 pages, Read Online | Download pdf file

TRE3001 photo
Loading ...
Loading ...
Loading ...
CLEANING AND MAINTENANCE
Cleaning sugary spills and melted plastics
NOTE
If pitting or indentations in the glass surface have already occurred, they can’t be
repaired.The cooktop glass will have to be replaced.
Sugary spillovers (such jellies, fudge, candy, and syrups) or melted plastics can cause
pitting of the cooktop surface. This is not covered under the warranty.
You should clean the spill while it is still hot. Take special care when removing hot
substances.
When using a scraper, make sure that it is new and the razor blade is still sharp. Do not
use a dull or nicked blade.
1.Turn off all surface burners. Remove hot pans.
2.Wearing an oven mitt, use a single-edge, razor-blade scraper to move the spill to a cool area
of the cooktop. Remove the spill with paper towels.
3.Wait until the cooktop has cooled, then remove any remaining spillover. Don’t use the surface
burners again until all of the residue has been completely removed.
Removing burned-on residue
1. Make sure that all surface burners are turned off, then let the cooktop cool.
2. Spread a few drops of ceramic cooktop cleaner on the entire burned residue area.
3. Using a cleaning pad for ceramic cooktops, rub the residue area. Apply pressure as needed.
4. If any residue remains, repeat the steps listed above as needed.
5. For additional protection, after all residue has been removed, polish the entire surface with a
ceramic cooktop cleaner and a paper towel.
Removing heavy, burned-on residue
1. Make sure that all surface burners are turned off, then let the cooktop cool.
2. Use a single-edge, razor-blade scraper at approximately a 45° angle against the glass
surface and scrape the residue. You need to apply remove the residue. Do not scrape the seal.
3. After scraping with the scraper, spread a few drops of ceramic cooktop cleaner on the
entire burned residue area. Use the cleaning pad to remove any remaining residue.
4. For additional protection, after all residue has been removed, polish the entire surface
with a ceramic cooktop cleaner and a paper towel.
Cleaning the cooktop seal
• Lay a wet cloth on the seal for a few minutes, then wipe clean with a nonabrasive cleaner.
17
Loading ...
Loading ...
Loading ...