Loading ...
Loading ...
Loading ...
Sensivity
Sensivity stands for the percentage of the body part of an acceptable target that enters the
predened region. Sensivity = 100 - S1/ST × 100. S1 stands for the target body part that goes
across the predened region. ST stands for the complete target body. The higher the value of
sensivity is, the more easily the alarm can be triggered.
Threshold
The threshold for the me of the objects removed from the region. If you set the value as 10,
alarm is triggered aer the object disappears from the region for 10s.
6.
Oponal: Repeat the above steps to set more regions.
7.
For the arming schedule sengs, see Set Arming Schedule . For the linkage method sengs, see
Linkage Method Sengs .
8.
Click Save.
Note
The funcon is only supported by certain models. The actual display varies with the models.
10.4 Road Trac
Vehicle Detecon and Mixed-trac Detecon are available for the road trac monitoring. The
device captures the passing motor vehicles and non-motor vehicles and uploads the relevant
informaon together with the captured pictures.
Note
●
For certain device models, you need to select Road Trac on VCA Resource page rst.
●
This funcon is only supported by certain device models.
10.4.1 Set Vehicle Detecon
The vehicles that enter the set lane can be detected and the picture of the vehicle and its license
plate can be captured and stored. Alarms will be triggered and captures can be uploaded.
Before You Start
Go to VCA → VCA Resource , and select Road Trac.
Steps
1.
Go to VCA → Road Trac → Detecon Conguraon , and select Vehicle Detecon as detecon
type.
2.
Check Enable.
3.
Select the total number of lanes.
4.
Click and drag the lane line to set its posion, or click and drag the line end to adjust the length
and angle of the line.
Network Camera User Manual
97
Loading ...
Loading ...
Loading ...